@@ -33,6 +33,8 @@
#define O2_SD_ADMA2 0xE7
#define O2_SD_INF_MOD 0xF1
#define O2_SD_MISC_CTRL4 0xFC
+#define O2_SD_MISC_CTRL 0x1C0
+#define O2_SD_PWR_FORCE_L0 0x0002
#define O2_SD_TUNING_CTRL 0x300
#define O2_SD_PLL_SETTING 0x304
#define O2_SD_MISC_SETTING 0x308
@@ -300,6 +302,8 @@ static int sdhci_o2_execute_tuning(struct mmc_host *mmc, u32 opcode)
{
struct sdhci_host *host = mmc_priv(mmc);
int current_bus_width = 0;
+ u32 scratch32 = 0;
+ u16 scratch = 0;
/*
* This handler only implements the eMMC tuning that is specific to
@@ -312,6 +316,17 @@ static int sdhci_o2_execute_tuning(struct mmc_host *mmc, u32 opcode)
if (WARN_ON((opcode != MMC_SEND_TUNING_BLOCK_HS200) &&
(opcode != MMC_SEND_TUNING_BLOCK)))
return -EINVAL;
+
+ /* Force power mode enter L0 */
+ scratch = sdhci_readw(host, O2_SD_MISC_CTRL);
+ scratch |= O2_SD_PWR_FORCE_L0;
+ sdhci_writew(host, scratch, O2_SD_MISC_CTRL);
+
+ /* wait DLL lock, timeout value 5ms */
+ if (readx_poll_timeout(sdhci_o2_pll_dll_wdt_control, host,
+ scratch32, (scratch32 & O2_DLL_LOCK_STATUS), 1, 5000))
+ pr_warn("%s: DLL can't lock in 5ms after force L0 during tuning.\n",
+ mmc_hostname(host->mmc));
/*
* Judge the tuning reason, whether caused by dll shift
* If cause by dll shift, should call sdhci_o2_dll_recovery
@@ -344,6 +359,11 @@ static int sdhci_o2_execute_tuning(struct mmc_host *mmc, u32 opcode)
sdhci_set_bus_width(host, current_bus_width);
}
+ /* Cancel force power mode enter L0 */
+ scratch = sdhci_readw(host, O2_SD_MISC_CTRL);
+ scratch &= ~(O2_SD_PWR_FORCE_L0);
+ sdhci_writew(host, scratch, O2_SD_MISC_CTRL);
+
sdhci_reset(host, SDHCI_RESET_CMD);
sdhci_reset(host, SDHCI_RESET_DATA);
Force chip enter L0 power state during SDR104 HW tuning to avoid tuning failure Signed-off-by: Shirley Her <shirley.her@bayhubtech.com> --- change in V1: 1. Force chip enter L0 power mode before HW tuning 2. Cancel force chip enter L0 power mode after HW tuning --- --- drivers/mmc/host/sdhci-pci-o2micro.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)