@@ -135,11 +135,15 @@ static int devkit8000_panel_enable_lcd(struct omap_dss_device *dssdev)
twl_i2c_write_u8(TWL4030_MODULE_GPIO, 0x80, REG_GPIODATADIR1);
twl_i2c_write_u8(TWL4030_MODULE_LED, 0x0, 0x0);
+ if (dssdev->reset_gpio != -EINVAL)
+ gpio_set_value(dssdev->reset_gpio, 1);
return 0;
}
static void devkit8000_panel_disable_lcd(struct omap_dss_device *dssdev)
{
+ if (dssdev->reset_gpio != -EINVAL)
+ gpio_set_value(dssdev->reset_gpio, 0);
}
static int devkit8000_panel_enable_dvi(struct omap_dss_device *dssdev)
@@ -180,6 +184,7 @@ static struct omap_dss_device devkit8000_lcd_device = {
.driver_name = "innolux_at_panel",
.type = OMAP_DISPLAY_TYPE_DPI,
.phy.dpi.data_lines = 24,
+ .reset_gpio = -EINVAL, /* will be replaced */
.platform_enable = devkit8000_panel_enable_lcd,
.platform_disable = devkit8000_panel_disable_lcd,
};
@@ -275,20 +280,15 @@ static int devkit8000_twl_gpio_setup(struct device *dev,
devkit8000_vmmc1_supply.dev = mmc[0].dev;
devkit8000_vsim_supply.dev = mmc[0].dev;
- /* REVISIT: need ehci-omap hooks for external VBUS
- * power switch and overcurrent detect
- */
-
- gpio_request(gpio + 1, "EHCI_nOC");
- gpio_direction_input(gpio + 1);
-
- /* TWL4030_GPIO_MAX + 0 == ledA, EHCI nEN_USB_PWR (out, active low) */
- gpio_request(gpio + TWL4030_GPIO_MAX, "nEN_USB_PWR");
- gpio_direction_output(gpio + TWL4030_GPIO_MAX, 1);
-
/* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */
gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1;
+ /* gpio + 1 is "LCD_PWREN" (out, active high) */
+ devkit8000_lcd_device.reset_gpio = gpio + 1;
+ gpio_request(devkit8000_lcd_device.reset_gpio, "LCD_PWREN");
+ /* Disable until needed */
+ gpio_direction_output(devkit8000_lcd_device.reset_gpio, 0);
+
/* gpio + 7 is "DVI_PD" (out, active low) */
devkit8000_dvi_device.reset_gpio = gpio + 7;
gpio_request(devkit8000_dvi_device.reset_gpio, "DVI PowerDown");