@@ -123,9 +123,9 @@ extern void allow_idle_sleep(void);
extern void omap1_pm_idle(void);
extern void omap1_pm_suspend(void);
-extern void omap7xx_cpu_suspend(unsigned short, unsigned short);
-extern void omap1510_cpu_suspend(unsigned short, unsigned short);
-extern void omap1610_cpu_suspend(unsigned short, unsigned short);
+extern void omap7xx_cpu_suspend(unsigned long, unsigned long);
+extern void omap1510_cpu_suspend(unsigned long, unsigned long);
+extern void omap1610_cpu_suspend(unsigned long, unsigned long);
extern void omap7xx_idle_loop_suspend(void);
extern void omap1510_idle_loop_suspend(void);
extern void omap1610_idle_loop_suspend(void);
@@ -58,6 +58,7 @@
*/
#if defined(CONFIG_ARCH_OMAP730) || defined(CONFIG_ARCH_OMAP850)
+ .align 3
ENTRY(omap7xx_cpu_suspend)
@ save registers on stack
@@ -137,6 +138,7 @@ ENTRY(omap7xx_cpu_suspend_sz)
#endif /* CONFIG_ARCH_OMAP730 || CONFIG_ARCH_OMAP850 */
#ifdef CONFIG_ARCH_OMAP15XX
+ .align 3
ENTRY(omap1510_cpu_suspend)
@ save registers on stack
@@ -211,6 +213,7 @@ ENTRY(omap1510_cpu_suspend_sz)
#endif /* CONFIG_ARCH_OMAP15XX */
#if defined(CONFIG_ARCH_OMAP16XX)
+ .align 3
ENTRY(omap1610_cpu_suspend)
@ save registers on stack
@@ -18,6 +18,7 @@
/*
* Reprograms ULPD and CKCTL.
*/
+ .align 3
ENTRY(omap1_sram_reprogram_clock)
stmfd sp!, {r0 - r12, lr} @ save registers on stack
@@ -92,7 +92,7 @@ extern void omap24xx_idle_loop_suspend(void);
extern void omap24xx_cpu_suspend(u32 dll_ctrl, void __iomem *sdrc_dlla_ctrl,
void __iomem *sdrc_power);
extern void omap34xx_cpu_suspend(u32 *addr, int save_state);
-extern void save_secure_ram_context(u32 *addr);
+extern int save_secure_ram_context(u32 *addr);
extern void omap3_save_scratchpad_contents(void);
extern unsigned int omap24xx_idle_loop_suspend_sz;
@@ -47,6 +47,7 @@
* Note: This code get's copied to internal SRAM at boot. When the OMAP
* wakes up it continues execution at the point it went to sleep.
*/
+ .align 3
ENTRY(omap24xx_idle_loop_suspend)
stmfd sp!, {r0, lr} @ save registers on stack
mov r0, #0 @ clear for mcr setup
@@ -82,6 +83,7 @@ ENTRY(omap24xx_idle_loop_suspend_sz)
* The DLL load value is not kept in RETENTION or OFF. It needs to be restored
* at wake
*/
+ .align 3
ENTRY(omap24xx_cpu_suspend)
stmfd sp!, {r0 - r12, lr} @ save registers on stack
mov r3, #0x0 @ clear for mcr call
@@ -118,6 +118,7 @@ ENTRY(enable_omap3630_toggle_l2_on_restore)
.text
/* Function to call rom code to save secure ram context */
+ .align 3
ENTRY(save_secure_ram_context)
stmfd sp!, {r1-r12, lr} @ save registers on stack
adr r3, api_params @ r3 points to parameters
@@ -169,6 +170,7 @@ ENTRY(save_secure_ram_context_sz)
* depending on the low power mode (non-OFF vs OFF modes),
* cf. 'Resume path for xxx mode' comments.
*/
+ .align 3
ENTRY(omap34xx_cpu_suspend)
stmfd sp!, {r0-r12, lr} @ save registers on stack
@@ -39,6 +39,7 @@
.text
+ .align 3
ENTRY(omap242x_sram_ddr_init)
stmfd sp!, {r0 - r12, lr} @ save registers on stack
@@ -143,6 +144,7 @@ ENTRY(omap242x_sram_ddr_init_sz)
* r0 = [PRCM_FULL | PRCM_HALF] r1 = SDRC_DLLA_CTRL value r2 = [DDR | SDR]
* PRCM_FULL = 2, PRCM_HALF = 1, DDR = 1, SDR = 0
*/
+ .align 3
ENTRY(omap242x_sram_reprogram_sdrc)
stmfd sp!, {r0 - r10, lr} @ save registers on stack
mov r3, #0x0 @ clear for mrc call
@@ -238,6 +240,7 @@ ENTRY(omap242x_sram_reprogram_sdrc_sz)
/*
* Set dividers and pll. Also recalculate DLL value for DDR and unlock mode.
*/
+ .align 3
ENTRY(omap242x_sram_set_prcm)
stmfd sp!, {r0-r12, lr} @ regs to stack
adr r4, pbegin @ addr of preload start
@@ -39,6 +39,7 @@
.text
+ .align 3
ENTRY(omap243x_sram_ddr_init)
stmfd sp!, {r0 - r12, lr} @ save registers on stack
@@ -143,6 +144,7 @@ ENTRY(omap243x_sram_ddr_init_sz)
* r0 = [PRCM_FULL | PRCM_HALF] r1 = SDRC_DLLA_CTRL value r2 = [DDR | SDR]
* PRCM_FULL = 2, PRCM_HALF = 1, DDR = 1, SDR = 0
*/
+ .align 3
ENTRY(omap243x_sram_reprogram_sdrc)
stmfd sp!, {r0 - r10, lr} @ save registers on stack
mov r3, #0x0 @ clear for mrc call
@@ -238,6 +240,7 @@ ENTRY(omap243x_sram_reprogram_sdrc_sz)
/*
* Set dividers and pll. Also recalculate DLL value for DDR and unlock mode.
*/
+ .align 3
ENTRY(omap243x_sram_set_prcm)
stmfd sp!, {r0-r12, lr} @ regs to stack
adr r4, pbegin @ addr of preload start
@@ -111,6 +111,7 @@
* since it will cause the ARM MMU to attempt to walk the page tables.
* These crashes may be intermittent.
*/
+ .align 3
ENTRY(omap3_sram_configure_core_dpll)
stmfd sp!, {r1-r12, lr} @ store regs to stack
@@ -12,7 +12,19 @@
#define __ARCH_ARM_OMAP_SRAM_H
#ifndef __ASSEMBLY__
-extern void * omap_sram_push(void * start, unsigned long size);
+#include <asm/fncpy.h>
+
+extern void *omap_sram_push_address(unsigned long size);
+
+/* Macro to push a function to the internal SRAM, using the fncpy API */
+#define omap_sram_push(funcp, size) ({ \
+ typeof(&(funcp)) _res = NULL; \
+ void *_sram_address = omap_sram_push_address(size); \
+ if (_sram_address) \
+ _res = fncpy(_sram_address, &(funcp), size); \
+ _res; \
+})
+
extern void omap_sram_reprogram_clock(u32 dpllctl, u32 ckctl);
extern void omap2_sram_ddr_init(u32 *slow_dll_ctrl, u32 fast_dll_ctrl,
@@ -242,7 +242,14 @@ static void __init omap_map_sram(void)
omap_sram_size - SRAM_BOOTLOADER_SZ);
}
-void * omap_sram_push(void * start, unsigned long size)
+/*
+ * Memory allocator for SRAM: calculates the new ceiling address
+ * for pushing a function using the fncpy API.
+ *
+ * Note that fncpy requires the returned address to be aligned
+ * to an 8-byte boundary.
+ */
+void *omap_sram_push_address(unsigned long size)
{
if (size > (omap_sram_ceil - (omap_sram_base + SRAM_BOOTLOADER_SZ))) {
printk(KERN_ERR "Not enough space in SRAM\n");
@@ -250,10 +257,7 @@ void * omap_sram_push(void * start, unsigned long size)
}
omap_sram_ceil -= size;
- omap_sram_ceil = ROUND_DOWN(omap_sram_ceil, sizeof(void *));
- memcpy((void *)omap_sram_ceil, start, size);
- flush_icache_range((unsigned long)omap_sram_ceil,
- (unsigned long)(omap_sram_ceil + size));
+ omap_sram_ceil = ROUND_DOWN(omap_sram_ceil, FNCPY_ALIGN);
return (void *)omap_sram_ceil;
}