@@ -2271,6 +2271,9 @@ static int usb_enumerate_device_otg(struct usb_device *udev)
"can't set HNP mode: %d\n",
err);
bus->b_hnp_enable = 0;
+ } else {
+ /* notify OTG fsm about a_set_b_hnp_enable */
+ usb_otg_kick_fsm(udev->bus->controller);
}
}
}
@@ -4234,8 +4237,13 @@ hub_port_init (struct usb_hub *hub, struct usb_device *udev, int port1,
*/
if (!hdev->parent) {
delay = HUB_ROOT_RESET_TIME;
- if (port1 == hdev->bus->otg_port)
+ if (port1 == hdev->bus->otg_port) {
hdev->bus->b_hnp_enable = 0;
+#ifdef CONFIG_USB_OTG
+ /* notify OTG fsm about a_set_b_hnp_enable change */
+ usb_otg_kick_fsm(hdev->bus->controller);
+#endif
+ }
}
/* Some low speed devices have problems with the quick delay, so */
This is the a_set_b_hnp_enable flag in the OTG state machine diagram and must be set when the A-Host has successfully set the b_hnp_enable feature of the OTG-B-Peripheral attached to it. When this bit changes we kick our OTG FSM to make note of the change and act accordingly. Signed-off-by: Roger Quadros <rogerq@ti.com> --- drivers/usb/core/hub.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-)