@@ -554,6 +554,7 @@ static void __init omap_sfh7741prox_init(void)
#ifdef CONFIG_OMAP_MUX
static struct omap_board_mux board_mux[] __initdata = {
+ OMAP4_MUX(USBB2_ULPITLL_CLK, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT),
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
#else
@@ -576,11 +577,12 @@ static void __init omap_4430sdp_init(void)
omap4_twl6030_hsmmc_init(mmc);
/* Power on the ULPI PHY */
- if (gpio_is_valid(OMAP4SDP_MDM_PWR_EN_GPIO)) {
- /* FIXME: Assumes pad is already muxed for GPIO mode */
- gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY VMDM_3V3");
+ status = gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY VMDM_3V3");
+ if (status)
+ pr_err("%s: Could not get USBB1 PHY GPIO\n");
+ else
gpio_direction_output(OMAP4SDP_MDM_PWR_EN_GPIO, 1);
- }
+
usb_ehci_init(&ehci_pdata);
usb_musb_init(&musb_board_data);