@@ -44,7 +44,6 @@
#define ETH_KS8851_IRQ 34
#define ETH_KS8851_POWER_ON 48
#define ETH_KS8851_QUART 138
-#define OMAP4SDP_MDM_PWR_EN_GPIO 157
#define OMAP4_SFH7741_SENSOR_OUTPUT_GPIO 184
#define OMAP4_SFH7741_ENABLE_GPIO 188
@@ -251,16 +250,6 @@ static void __init omap_4430sdp_init_irq(void)
gic_init_irq();
}
-static const struct usbhs_omap_board_data usbhs_bdata __initconst = {
- .port_mode[0] = OMAP_EHCI_PORT_MODE_PHY,
- .port_mode[1] = OMAP_USBHS_PORT_MODE_UNUSED,
- .port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED,
- .phy_reset = false,
- .reset_gpio_port[0] = -EINVAL,
- .reset_gpio_port[1] = -EINVAL,
- .reset_gpio_port[2] = -EINVAL,
-};
-
static struct omap_musb_board_data musb_board_data = {
.interface_type = MUSB_INTERFACE_UTMI,
.mode = MUSB_OTG,
@@ -577,14 +566,6 @@ static void __init omap_4430sdp_init(void)
omap_serial_init();
omap4_twl6030_hsmmc_init(mmc);
- /* Power on the ULPI PHY */
- status = gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY VMDM_3V3");
- if (status)
- pr_err("%s: Could not get USBB1 PHY GPIO\n", __func__);
- else
- gpio_direction_output(OMAP4SDP_MDM_PWR_EN_GPIO, 1);
-
- usbhs_init(&usbhs_bdata);
usb_musb_init(&musb_board_data);
status = omap_ethernet_init();