diff mbox series

[v1,1/3] pinctrl: Keep enum pin_config_param ordered by name

Message ID 20210412140741.39946-1-andriy.shevchenko@linux.intel.com (mailing list archive)
State New, archived
Headers show
Series [v1,1/3] pinctrl: Keep enum pin_config_param ordered by name | expand

Commit Message

Andy Shevchenko April 12, 2021, 2:07 p.m. UTC
It seems the ordering is by name. Keep it that way.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 include/linux/pinctrl/pinconf-generic.h | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

Comments

Linus Walleij April 22, 2021, 12:03 a.m. UTC | #1
On Mon, Apr 12, 2021 at 4:07 PM Andy Shevchenko
<andriy.shevchenko@linux.intel.com> wrote:

> It seems the ordering is by name. Keep it that way.
>
> Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>

Patches applied, nice spring cleaning so why not!

Yours,
Linus Walleij
diff mbox series

Patch

diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 6aeb711f7cd1..188db8d84162 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -90,6 +90,7 @@  struct pinctrl_map;
  * 	value on the line. Use argument 1 to indicate high level, argument 0 to
  *	indicate low level. (Please see Documentation/driver-api/pinctl.rst,
  *	section "GPIO mode pitfalls" for a discussion around this parameter.)
+ * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
  * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power
  *	supplies, the argument to this parameter (on a custom format) tells
  *	the driver which alternative power source to use.
@@ -101,7 +102,6 @@  struct pinctrl_map;
  *	or latch delay (on outputs) this parameter (in a custom format)
  *	specifies the clock skew or latch delay. It typically controls how
  *	many double inverters are put in front of the line.
- * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
  * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if
  *	you need to pass in custom configurations to the pin controller, use
  *	PIN_CONFIG_END+1 as the base offset.
@@ -127,11 +127,11 @@  enum pin_config_param {
 	PIN_CONFIG_LOW_POWER_MODE,
 	PIN_CONFIG_OUTPUT_ENABLE,
 	PIN_CONFIG_OUTPUT,
+	PIN_CONFIG_PERSIST_STATE,
 	PIN_CONFIG_POWER_SOURCE,
 	PIN_CONFIG_SLEEP_HARDWARE_STATE,
 	PIN_CONFIG_SLEW_RATE,
 	PIN_CONFIG_SKEW_DELAY,
-	PIN_CONFIG_PERSIST_STATE,
 	PIN_CONFIG_END = 0x7F,
 	PIN_CONFIG_MAX = 0xFF,
 };