@@ -292,15 +292,6 @@ static struct platform_device h2_kp_device = {
#define H2_IRDA_FIRSEL_GPIO_PIN 17
-#if defined(CONFIG_OMAP_IR) || defined(CONFIG_OMAP_IR_MODULE)
-static int h2_transceiver_mode(struct device *dev, int state)
-{
- /* SIR when low, else MIR/FIR when HIGH */
- gpio_set_value(H2_IRDA_FIRSEL_GPIO_PIN, !(state & IR_SIRMODE));
- return 0;
-}
-#endif
-
static struct omap_irda_config h2_irda_data = {
.transceiver_cap = IR_SIRMODE | IR_MIRMODE | IR_FIRMODE,
.rx_channel = OMAP_DMA_UART3_RX,
@@ -437,15 +428,6 @@ static void __init h2_init(void)
/* omap_cfg_reg(U19_ARMIO1); */ /* CD */
omap_cfg_reg(BALLOUT_V8_ARMIO3); /* WP */
- /* Irda */
-#if defined(CONFIG_OMAP_IR) || defined(CONFIG_OMAP_IR_MODULE)
- omap_writel(omap_readl(FUNC_MUX_CTRL_A) | 7, FUNC_MUX_CTRL_A);
- if (gpio_request(H2_IRDA_FIRSEL_GPIO_PIN, "IRDA mode") < 0)
- BUG();
- gpio_direction_output(H2_IRDA_FIRSEL_GPIO_PIN, 0);
- h2_irda_data.transceiver_mode = h2_transceiver_mode;
-#endif
-
platform_add_devices(h2_devices, ARRAY_SIZE(h2_devices));
omap_board_config = h2_config;
omap_board_config_size = ARRAY_SIZE(h2_config);
@@ -345,10 +345,6 @@ static void __init omap_h4_init(void)
* You have to mux them off in device drivers later on
* if not needed.
*/
-#if defined(CONFIG_OMAP_IR) || defined(CONFIG_OMAP_IR_MODULE)
- omap_cfg_reg(K15_24XX_UART3_TX);
- omap_cfg_reg(K14_24XX_UART3_RX);
-#endif
#if defined(CONFIG_KEYBOARD_OMAP) || defined(CONFIG_KEYBOARD_OMAP_MODULE)
if (omap_has_menelaus()) {