@@ -226,6 +226,17 @@
gpio = <&gpio6 4 GPIO_ACTIVE_HIGH>; /* GPIO_164 */
};
+ /* wl1251 wifi+bt module */
+ wlan_en: fixed-regulator-wg7210_en {
+ compatible = "regulator-fixed";
+ regulator-name = "vwlan";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ startup-delay-us = <50000>;
+ enable-active-high;
+ gpio = <&gpio1 23 GPIO_ACTIVE_HIGH>;
+ };
+
/* wg7210 (wifi+bt module) 32k clock buffer */
wg7210_32k: fixed-regulator-wg7210_32k {
compatible = "regulator-fixed";
@@ -522,9 +533,30 @@
/*wp-gpios = <&gpio4 31 GPIO_ACTIVE_HIGH>;*/ /* GPIO_127 */
};
-/* mmc3 is probed using pdata-quirks to pass wl1251 card data */
&mmc3 {
- status = "disabled";
+ vmmc-supply = <&wlan_en>;
+
+ bus-width = <4>;
+ non-removable;
+ ti,non-removable;
+ cap-power-off-card;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&mmc3_pins>;
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ wlan: wifi@1 {
+ compatible = "ti,wl1251";
+
+ reg = <1>;
+
+ interrupt-parent = <&gpio1>;
+ interrupts = <21 IRQ_TYPE_LEVEL_HIGH>; /* GPIO_21 */
+
+ ti,wl1251-has-eeprom;
+ };
};
/* bluetooth*/
Since v4.7 the dma initialization requires that there is a device tree property for "rx" and "tx" channels which is not provided by the pdata-quirks initialization. By conversion of the mmc3 setup to device tree this will finally allows to remove the OpenPandora wlan specific omap3 data-quirks. Fixes: 81eef6ca9201 ("mmc: omap_hsmmc: Use dma_request_chan() for requesting DMA channel") Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Cc: <stable@vger.kernel.org> # 4.7.0 --- arch/arm/boot/dts/omap3-pandora-common.dtsi | 36 +++++++++++++++++++-- 1 file changed, 34 insertions(+), 2 deletions(-)