mbox series

[PATCHv3,0/6] Meson-8b and Meson-gxbb Fix some missing code

Message ID 20210817041548.1276-1-linux.amoon@gmail.com
Headers show
Series Meson-8b and Meson-gxbb Fix some missing code | expand

Message

Anand Moon Aug. 17, 2021, 4:15 a.m. UTC
On Odroid C1+ and Odroid C2 USB feature is broken

It's being observed the after initiation of USB phy
the USB port goes in to suspend state, If we pass usbcore.autosuspend=-1
via command line USB hotplug seen to be working.

Another issue I observed is increase of USB interrupts event
even if there is not much activity on USB ports.

$ cat /proc/interrupts | grep usb
 35:   26462800          0          0          0     GIC-0  63 Level
			c90c0000.usb, dwc2_hsotg:usb1
8
Changes added power node to usb phy and small code cleanup
in usb phy.


Previous version RFC.
[0] https://patchwork.kernel.org/project/linux-amlogic/cover/20210617194154.2397-1-linux.amoon@gmail.com/
Dopped the reorder of code changes as of now.

V1 > changes Fixed the GPIO input signal on Odroid C1+/C2
     New patch added to fix Odroid C2.

[1] https://lore.kernel.org/linux-devicetree/20210716103651.1455-1-linux.amoon@gmail.com/

V2 > changes Fixed the GPIO polarity for Odroid C1
     fix the power source from phy-supply to vbus-supply 
     added new patches to fix resolve some issues.

Thanks
-Anand

Anand Moon (6):
  ARM: dts: meson8b: odroidc1: Add usb phy power node
  ARM: dts: meson8b: odroidc1: Set usb power source to always on
  arm64: dts: amlogic: odroidc2: Fix the chip enable signal for usb
    power
  arm64: dts: amlogic: odroidc2: use vbus-supply for power source for
    usb nodes
  phy: amlogic: meson8b-usb2: Power off the PHY by putting it into reset
    mode
  phy: amlogic: meson8b-usb2: don't log an error on -EPROBE_DEFER

 arch/arm/boot/dts/meson8b-odroidc1.dts        | 21 ++++++++++++++++++-
 .../boot/dts/amlogic/meson-gxbb-odroidc2.dts  | 10 ++++-----
 drivers/phy/amlogic/phy-meson8b-usb2.c        |  8 +++++--
 3 files changed, 30 insertions(+), 9 deletions(-)