diff mbox series

[02/22] ARM: dts: sun8i: v3s: Parent the CSI module clock to the ISP PLL

Message ID 20210910184147.336618-3-paul.kocialkowski@bootlin.com
State Not Applicable
Headers show
Series Allwinner A31/A83T MIPI CSI-2 Support and A31 ISP Support | expand

Commit Message

Paul Kocialkowski Sept. 10, 2021, 6:41 p.m. UTC 
At reset time, the CSI module clock is parented to the video PLL, which
is used by the display engine. While the CSI module clock needs to be
clocked at precisely 297 MHz, the display engine will need to adjust its
clock usage depending on the display pixel rate.

As a result, the video PLL may be reconfigured to fit the need of the
display engine, which will break the CSI hardware.

A good way to work around this is to reparent the CSI module clock to
the ISP PLL (like it is done in the Allwinner SDK). Do this using the
device-tree assigned-clock properties.

Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com>
---
 arch/arm/boot/dts/sun8i-v3s.dtsi | 3 +++
 1 file changed, 3 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/sun8i-v3s.dtsi b/arch/arm/boot/dts/sun8i-v3s.dtsi
index 776913b3f85f..a77b63362a1d 100644
--- a/arch/arm/boot/dts/sun8i-v3s.dtsi
+++ b/arch/arm/boot/dts/sun8i-v3s.dtsi
@@ -622,6 +622,9 @@  csi1: camera@1cb4000 {
 			clock-names = "bus", "mod", "ram";
 			resets = <&ccu RST_BUS_CSI>;
 			status = "disabled";
+
+			assigned-clocks = <&ccu CLK_CSI1_SCLK>;
+			assigned-clock-parents = <&ccu CLK_PLL_ISP>;
 		};
 
 		gic: interrupt-controller@1c81000 {