| Message ID | 20211111164313.649-2-a-govindraju@ti.com |
|---|---|
| State | Changes Requested |
| Headers | show |
| Series | CAN TRANSCEIVER: Add support for setting mux | expand |
diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml index 6107880e5246..24cc3c04b85d 100644 --- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml +++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml @@ -37,6 +37,11 @@ properties: max bit rate supported in bps minimum: 1 + mux-controls: + description: + mux controller node to route the signals from controller to + transceiver. + required: - compatible - '#phy-cells' @@ -53,4 +58,5 @@ examples: max-bitrate = <5000000>; standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>; enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>; + mux-controls = <&mux0>; };
On some boards, for routing CAN signals from controller to transceivers, muxes might need to be set. Use mux-controls property can be used for model this. Signed-off-by: Aswath Govindraju <a-govindraju@ti.com> --- Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml | 6 ++++++ 1 file changed, 6 insertions(+)