@@ -553,7 +553,6 @@ static int cdns_dsi_check_conf(struct cdns_dsi *dsi,
{
struct cdns_dsi_output *output = &dsi->output;
struct phy_configure_opts_mipi_dphy *phy_cfg = &output->phy_opts.mipi_dphy;
- unsigned long dsi_hss_hsa_hse_hbp;
unsigned int nlanes = output->dev->lanes;
int ret;
@@ -575,20 +574,6 @@ static int cdns_dsi_check_conf(struct cdns_dsi *dsi,
if (ret)
return ret;
- dsi_hss_hsa_hse_hbp = dsi_cfg->hbp + DSI_HBP_FRAME_OVERHEAD;
- if (output->dev->mode_flags & MIPI_DSI_MODE_VIDEO_SYNC_PULSE)
- dsi_hss_hsa_hse_hbp += dsi_cfg->hsa + DSI_HSA_FRAME_OVERHEAD;
-
- /*
- * Make sure DPI(HFP) > DSI(HSS+HSA+HSE+HBP) to guarantee that the FIFO
- * is empty before we start a receiving a new line on the DPI
- * interface.
- */
- if ((u64)phy_cfg->hs_clk_rate *
- (mode->hsync_start - mode->hdisplay) * nlanes <
- (u64)dsi_hss_hsa_hse_hbp * mode->clock * 1000)
- return -EINVAL;
-
return 0;
}
The driver checks if "DPI(HFP) > DSI(HSS+HSA+HSE+HBP)", and rejects the mode if not. However, testing shows that this doesn't hold at all. I can set the hfp to very small values, with no errors. The feedback from the HW team also was that the check is not right, although it's not clear if there's a way to validate the FIFO emptying. The check rejects quite a lot of modes, apparently for no good reason, so drop the check. Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ideasonboard.com> --- drivers/gpu/drm/bridge/cadence/cdns-dsi-core.c | 15 --------------- 1 file changed, 15 deletions(-)