[v6,1/5] dt-bindings: thermal: qcom-spmi-temp-alarm: Fix documentation of 'reg'

Commit Message

Matthias Kaehlcke July 31, 2018, 6:45 p.m. UTC

The documentation claims that the 'reg' property consists of two values,
the SPMI address and the length of the controller's registers. However
the SPMI bus to which it is added specifies "#size-cells = <0>;". Remove
the controller register length from the documentation of the field and the
example.

Signed-off-by: Matthias Kaehlcke <[e-mail]>
Reviewed-by: Douglas Anderson <[e-mail]>
---
Changes in v6:
- patch added to the series
---
 .../devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt     | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

Patch

diff --git a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
index 290ec06fa33a..86fb41fe772f 100644
--- a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
+++ b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
@@ -6,8 +6,7 @@  interrupt signal and status register to identify high PMIC die temperature.
 
 Required properties:
 - compatible:      Should contain "qcom,spmi-temp-alarm".
-- reg:             Specifies the SPMI address and length of the controller's
-                   registers.
+- reg:             Specifies the SPMI address.
 - interrupts:      PMIC temperature alarm interrupt.
 - #thermal-sensor-cells: Should be 0. See thermal.txt for a description.
 
@@ -20,7 +19,7 @@  Example:
 
 	pm8941_temp: thermal-alarm@2400 {
 		compatible = "qcom,spmi-temp-alarm";
-		reg = <0x2400 0x100>;
+		reg = <0x2400>;
 		interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
 		#thermal-sensor-cells = <0>;