diff mbox series

[v4,3/6] dt-bindings: ap806: document the thermal interrupt capabilities

Message ID 20181212093645.14752-4-miquel.raynal@bootlin.com (mailing list archive)
State Accepted
Delegated to: Eduardo Valentin
Headers show
Series Add hw overheat IRQ support to Marvell thermal driver | expand

Commit Message

Miquel Raynal Dec. 12, 2018, 9:36 a.m. UTC
The thermal IP can produce interrupts on overheat situation.
Describe them.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 .../bindings/arm/marvell/ap806-system-controller.txt       | 7 +++++++
 1 file changed, 7 insertions(+)

Comments

Rob Herring Dec. 17, 2018, 9:45 p.m. UTC | #1
On Wed, 12 Dec 2018 10:36:42 +0100, Miquel Raynal wrote:
> The thermal IP can produce interrupts on overheat situation.
> Describe them.
> 
> Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
> ---
>  .../bindings/arm/marvell/ap806-system-controller.txt       | 7 +++++++
>  1 file changed, 7 insertions(+)
> 

Reviewed-by: Rob Herring <robh@kernel.org>
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt b/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt
index 3fd21bb7cb37..7b8b8eb0191f 100644
--- a/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt
+++ b/Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt
@@ -114,12 +114,17 @@  Documentation/devicetree/bindings/thermal/thermal.txt
 The thermal IP can probe the temperature all around the processor. It
 may feature several channels, each of them wired to one sensor.
 
+It is possible to setup an overheat interrupt by giving at least one
+critical point to any subnode of the thermal-zone node.
+
 Required properties:
 - compatible: must be one of:
   * marvell,armada-ap806-thermal
 - reg: register range associated with the thermal functions.
 
 Optional properties:
+- interrupts: overheat interrupt handle. Should point to line 18 of the
+  SEI irqchip. See interrupt-controller/interrupts.txt
 - #thermal-sensor-cells: shall be <1> when thermal-zones subnodes refer
   to this IP and represents the channel ID. There is one sensor per
   channel. O refers to the thermal IP internal channel, while positive
@@ -133,6 +138,8 @@  ap_syscon1: system-controller@6f8000 {
 	ap_thermal: thermal-sensor@80 {
 		compatible = "marvell,armada-ap806-thermal";
 		reg = <0x80 0x10>;
+		interrupt-parent = <&sei>;
+		interrupts = <18>;
 		#thermal-sensor-cells = <1>;
 	};
 };