[v7,4/6] ARM: dts: exynos: Add interconnect properties to Exynos4412 bus nodes

Commit Message

Sylwester Nawrocki/Kernel \(PLT\) /SRPOL/Staff Engineer/Samsung Electronics Oct. 30, 2020, 12:51 p.m. UTC

This patch adds the following properties for Exynos4412 interconnect
bus nodes:
 - interconnects: to declare connections between nodes in order to
   guarantee PM QoS requirements between nodes,
 - #interconnect-cells: required by the interconnect framework,
 - samsung,data-clk-ratio: which allows to specify minimum data clock
   frequency corresponding to requested bandwidth for each bus.

Note that #interconnect-cells is always zero and node IDs are not
hardcoded anywhere.

Signed-off-by: Artur Świgoń <[e-mail]>
Signed-off-by: Sylwester Nawrocki <[e-mail]>
---
Changes for v7:
 - adjusted to the DT property changes: "interconnects" instead
   of "samsung,interconnect-parent", "samsung,data-clk-ratio"
   instead of "bus-width".

Changes for v6:
 - added bus-width property in bus_dmc node.

Changes for v5:
 - adjust to renamed exynos,interconnect-parent-node property,
 - add properties in common exynos4412.dtsi file rather than
   in Odroid specific odroid4412-odroid-common.dtsi.
---
 arch/arm/boot/dts/exynos4412.dtsi | 6 ++++++
 1 file changed, 6 insertions(+)

Patch

diff --git a/arch/arm/boot/dts/exynos4412.dtsi b/arch/arm/boot/dts/exynos4412.dtsi
index e76881d..4999e68 100644
--- a/arch/arm/boot/dts/exynos4412.dtsi
+++ b/arch/arm/boot/dts/exynos4412.dtsi
@@ -383,6 +383,8 @@ 
 			clocks = <&clock CLK_DIV_DMC>;
 			clock-names = "bus";
 			operating-points-v2 = <&bus_dmc_opp_table>;
+			samsung,data-clock-ratio = <4>;
+			#interconnect-cells = <0>;
 			status = "disabled";
 		};
 
@@ -452,6 +454,8 @@ 
 			clocks = <&clock CLK_DIV_GDL>;
 			clock-names = "bus";
 			operating-points-v2 = <&bus_leftbus_opp_table>;
+			interconnects = <&bus_dmc>;
+			#interconnect-cells = <0>;
 			status = "disabled";
 		};
 
@@ -468,6 +472,8 @@ 
 			clocks = <&clock CLK_ACLK160>;
 			clock-names = "bus";
 			operating-points-v2 = <&bus_display_opp_table>;
+			interconnects = <&bus_leftbus &bus_dmc>;
+			#interconnect-cells = <0>;
 			status = "disabled";
 		};