@@ -1808,7 +1808,7 @@ static int fec_enet_mdio_read(struct mii_bus *bus, int mii_id, int regnum)
int ret = 0, frame_start, frame_addr, frame_op;
bool is_c45 = !!(regnum & MII_ADDR_C45);
- ret = pm_runtime_get_sync(dev);
+ ret = pm_runtime_general_get(dev);
if (ret < 0)
return ret;
@@ -1867,11 +1867,9 @@ static int fec_enet_mdio_write(struct mii_bus *bus, int mii_id, int regnum,
int ret, frame_start, frame_addr;
bool is_c45 = !!(regnum & MII_ADDR_C45);
- ret = pm_runtime_get_sync(dev);
+ ret = pm_runtime_general_get(dev);
if (ret < 0)
return ret;
- else
- ret = 0;
if (is_c45) {
frame_start = FEC_MMFR_ST_C45;
@@ -2275,7 +2273,7 @@ static void fec_enet_get_regs(struct net_device *ndev,
u32 i, off;
int ret;
- ret = pm_runtime_get_sync(dev);
+ ret = pm_runtime_general_get(dev);
if (ret < 0)
return;
@@ -2976,7 +2974,7 @@ fec_enet_open(struct net_device *ndev)
int ret;
bool reset_again;
- ret = pm_runtime_get_sync(&fep->pdev->dev);
+ ret = pm_runtime_general_get(&fep->pdev->dev);
if (ret < 0)
return ret;
@@ -3770,7 +3768,7 @@ fec_drv_remove(struct platform_device *pdev)
struct device_node *np = pdev->dev.of_node;
int ret;
- ret = pm_runtime_get_sync(&pdev->dev);
+ ret = pm_runtime_general_get(&pdev->dev);
if (ret < 0)
return ret;
pm_runtime_get_sync() will increment pm usage at first and it will resume the device later. If runtime of the device has error or device is in inaccessible state(or other error state), resume operation will fail. If we do not call put operation to decrease the reference, it will result in reference count leak. Moreover, this device cannot enter the idle state and always stay busy or other non-idle state later. So we fixed it by replacing it with pm_runtime_general_get. Fixes: 8fff755e9f8d0 ("net: fec: Ensure clocks are enabled while using mdio bus") Signed-off-by: Zhang Qilong <zhangqilong3@huawei.com> --- drivers/net/ethernet/freescale/fec_main.c | 12 +++++------- 1 file changed, 5 insertions(+), 7 deletions(-)