@@ -173,56 +173,6 @@ static void disable_8960(struct tsens_priv *priv)
regmap_write(priv->tm_map, CNTL_ADDR, reg_cntl);
}
-static int init_8960(struct tsens_priv *priv)
-{
- int ret, i;
- u32 reg_cntl;
-
- priv->tm_map = dev_get_regmap(priv->dev, NULL);
- if (!priv->tm_map)
- return -ENODEV;
-
- /*
- * The status registers for each sensor are discontiguous
- * because some SoCs have 5 sensors while others have more
- * but the control registers stay in the same place, i.e
- * directly after the first 5 status registers.
- */
- for (i = 0; i < priv->num_sensors; i++) {
- if (i >= 5)
- priv->sensor[i].status = S0_STATUS_ADDR + 40;
- priv->sensor[i].status += i * 4;
- }
-
- reg_cntl = SW_RST;
- ret = regmap_update_bits(priv->tm_map, CNTL_ADDR, SW_RST, reg_cntl);
- if (ret)
- return ret;
-
- if (priv->num_sensors > 1) {
- reg_cntl |= SLP_CLK_ENA | (MEASURE_PERIOD << 18);
- reg_cntl &= ~SW_RST;
- ret = regmap_update_bits(priv->tm_map, CONFIG_ADDR,
- CONFIG_MASK, CONFIG);
- } else {
- reg_cntl |= SLP_CLK_ENA_8660 | (MEASURE_PERIOD << 16);
- reg_cntl &= ~CONFIG_MASK_8660;
- reg_cntl |= CONFIG_8660 << CONFIG_SHIFT_8660;
- }
-
- reg_cntl |= GENMASK(priv->num_sensors - 1, 0) << SENSOR0_SHIFT;
- ret = regmap_write(priv->tm_map, CNTL_ADDR, reg_cntl);
- if (ret)
- return ret;
-
- reg_cntl |= EN;
- ret = regmap_write(priv->tm_map, CNTL_ADDR, reg_cntl);
- if (ret)
- return ret;
-
- return 0;
-}
-
static int calibrate_8960(struct tsens_priv *priv)
{
int i;
@@ -346,7 +296,7 @@ static const struct reg_field tsens_8960_regfields[MAX_REGFIELDS] = {
};
static const struct tsens_ops ops_8960 = {
- .init = init_8960,
+ .init = init_common,
.calibrate = calibrate_8960,
.get_temp = get_temp_8960,
.enable = enable_8960,
Use init_common and drop custom init for msm8960. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> --- drivers/thermal/qcom/tsens-8960.c | 52 +------------------------------ 1 file changed, 1 insertion(+), 51 deletions(-)