@@ -5899,6 +5899,39 @@ static int add_all_stripe_bios(struct r5conf *conf,
return ret;
}
+enum reshape_loc {
+ LOC_NO_RESHAPE,
+ LOC_AHEAD_OF_RESHAPE,
+ LOC_INSIDE_RESHAPE,
+ LOC_BEHIND_RESHAPE,
+};
+
+static enum reshape_loc get_reshape_loc(struct mddev *mddev,
+ struct r5conf *conf, sector_t logical_sector)
+{
+ sector_t reshape_progress, reshape_safe;
+ /*
+ * Spinlock is needed as reshape_progress may be
+ * 64bit on a 32bit platform, and so it might be
+ * possible to see a half-updated value
+ * Of course reshape_progress could change after
+ * the lock is dropped, so once we get a reference
+ * to the stripe that we think it is, we will have
+ * to check again.
+ */
+ spin_lock_irq(&conf->device_lock);
+ reshape_progress = conf->reshape_progress;
+ reshape_safe = conf->reshape_safe;
+ spin_unlock_irq(&conf->device_lock);
+ if (reshape_progress == MaxSector)
+ return LOC_NO_RESHAPE;
+ if (ahead_of_reshape(mddev, logical_sector, reshape_progress))
+ return LOC_AHEAD_OF_RESHAPE;
+ if (ahead_of_reshape(mddev, logical_sector, reshape_safe))
+ return LOC_INSIDE_RESHAPE;
+ return LOC_BEHIND_RESHAPE;
+}
+
static enum stripe_result make_stripe_request(struct mddev *mddev,
struct r5conf *conf, struct stripe_request_ctx *ctx,
sector_t logical_sector, struct bio *bi)
@@ -5913,28 +5946,14 @@ static enum stripe_result make_stripe_request(struct mddev *mddev,
seq = read_seqcount_begin(&conf->gen_lock);
if (unlikely(conf->reshape_progress != MaxSector)) {
- /*
- * Spinlock is needed as reshape_progress may be
- * 64bit on a 32bit platform, and so it might be
- * possible to see a half-updated value
- * Of course reshape_progress could change after
- * the lock is dropped, so once we get a reference
- * to the stripe that we think it is, we will have
- * to check again.
- */
- spin_lock_irq(&conf->device_lock);
- if (ahead_of_reshape(mddev, logical_sector,
- conf->reshape_progress)) {
- previous = 1;
- } else {
- if (ahead_of_reshape(mddev, logical_sector,
- conf->reshape_safe)) {
- spin_unlock_irq(&conf->device_lock);
- ret = STRIPE_SCHEDULE_AND_RETRY;
- goto out;
- }
+ enum reshape_loc loc = get_reshape_loc(mddev, conf,
+ logical_sector);
+ if (loc == LOC_INSIDE_RESHAPE) {
+ ret = STRIPE_SCHEDULE_AND_RETRY;
+ goto out;
}
- spin_unlock_irq(&conf->device_lock);
+ if (loc == LOC_AHEAD_OF_RESHAPE)
+ previous = 1;
}
new_sector = raid5_compute_sector(conf, logical_sector, previous,
@@ -6112,8 +6131,7 @@ static bool raid5_make_request(struct mddev *mddev, struct bio * bi)
/* Bail out if conflicts with reshape and REQ_NOWAIT is set */
if ((bi->bi_opf & REQ_NOWAIT) &&
(conf->reshape_progress != MaxSector) &&
- !ahead_of_reshape(mddev, logical_sector, conf->reshape_progress) &&
- ahead_of_reshape(mddev, logical_sector, conf->reshape_safe)) {
+ get_reshape_loc(mddev, conf, logical_sector) == LOC_INSIDE_RESHAPE) {
bio_wouldblock_error(bi);
if (rw == WRITE)
md_write_end(mddev);
When handling an IO request, MD checks if a reshape is currently happening, and if so, where the IO sector is in relation to the reshape progress. MD uses conf->reshape_progress for both of these tasks. When the reshape finishes, conf->reshape_progress is set to MaxSector. If this occurs after MD checks if the reshape is currently happening but before it calls ahead_of_reshape(), then ahead_of_reshape() will end up comparing the IO sector against MaxSector. During a backwards reshape, this will make MD think the IO sector is in the area not yet reshaped, causing it to use the previous configuration, and map the IO to the sector where that data was before the reshape. This bug can be triggered by running the lvm2 lvconvert-raid-reshape-linear_to_raid6-single-type.sh test in a loop, although it's very hard to reproduce. Fix this by factoring the code that checks where the IO sector is in relation to the reshape out to a helper called get_reshape_loc(), which reads reshape_progress and reshape_safe while holding the device_lock, and then rechecks if the reshape has finished before calling ahead_of_reshape with the saved values. Also use the helper during the REQ_NOWAIT check to see if the location is inside of the reshape region. Fixes: fef9c61fdfabf ("md/raid5: change reshape-progress measurement to cope with reshaping backwards.") Signed-off-by: Benjamin Marzinski <bmarzins@redhat.com> --- Changes in v2: - factor the code that checks where the IO sector is in relation to the reshape out to a helper function, and also call this for the REQ_NOWAIT check. drivers/md/raid5.c | 64 +++++++++++++++++++++++++++++----------------- 1 file changed, 41 insertions(+), 23 deletions(-)