diff mbox series

[mlx5-next,06/14] net/mlx5: E-Switch, set flow source for send to uplink rule

Message ID 20210803231959.26513-7-saeed@kernel.org (mailing list archive)
State Not Applicable
Headers show
Series mlx5 single FDB for lag | expand

Commit Message

Saeed Mahameed Aug. 3, 2021, 11:19 p.m. UTC 
From: Ariel Levkovich <lariel@nvidia.com>

Set the flow source param to local vport for the uplink rep
send-to-vport rule.

This will comply with the recent changes in SW steering that
use the flow source as an indication for the rule type - rx or tx.

Since the uplink send-to-vport rule is forwarding traffic to the wire
it has to indicate that it is an sx rule and can't use the any port
value in the flow source.

Signed-off-by: Ariel Levkovich <lariel@nvidia.com>
Reviewed-by: Roi Dayan <roid@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
---
 drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c | 3 +++
 1 file changed, 3 insertions(+)
diff mbox series

Patch

diff --git a/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c b/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c
index 12567002997f..1735be77e1fd 100644
--- a/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c
+++ b/drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c
@@ -963,6 +963,9 @@  mlx5_eswitch_add_send_to_vport_rule(struct mlx5_eswitch *on_esw,
 	dest.vport.flags |= MLX5_FLOW_DEST_VPORT_VHCA_ID;
 	flow_act.action = MLX5_FLOW_CONTEXT_ACTION_FWD_DEST;
 
+	if (rep->vport == MLX5_VPORT_UPLINK)
+		spec->flow_context.flow_source = MLX5_FLOW_CONTEXT_FLOW_SOURCE_LOCAL_VPORT;
+
 	flow_rule = mlx5_add_flow_rules(on_esw->fdb_table.offloads.slow_fdb,
 					spec, &flow_act, &dest, 1);
 	if (IS_ERR(flow_rule))