mbox series

[v2,0/4] Converter R-Car DU to the DRM bridge connector helper

Message ID 20201216005021.19518-1-laurent.pinchart+renesas@ideasonboard.com (mailing list archive)
Headers show
Series Converter R-Car DU to the DRM bridge connector helper | expand

Message

Laurent Pinchart Dec. 16, 2020, 12:50 a.m. UTC
Hello,

This patch series converts the R-Car DU driver to use the DRM bridge
connector helper drm_bridge_connector_init().

The bulk of the v1 series was converting the adv7511, simple-bridge and
dw-hdmi drivers to make connector creation optional (through the
DRM_BRIDGE_ATTACH_NO_CONNECTOR flag), and have already been merged. v2
includes the remaining patches.

Patch 1/4 addresses the rcar-lvds driver. Instead of implementing direct
support for DRM_BRIDGE_ATTACH_NO_CONNECTOR, it simply removes code that
shouldn't have been in the driver in the first place by switching to the
panel bridge helper.

Patches 2/4 then adds support to the dw-hdmi driver to attach to a
downstream bridge if one is specified in DT. As the DT port number
corresponding to the video output differs between platforms that
integrate the dw-hdmi (some of them even don't have a video output port,
which should probably be fixed, but that's out of scope for this
series), the port number has to be specified by the platform glue layer.
Patch 3/4 does so for the R-Car dw-hdmi driver.

Patch 4/4 finally makes use of the drm_bridge_connector_init() helper.

The series depends on "[PATCH 27/27] drm: Add default modes for
connectors in unknown state" ([1]) to avoid a breakage on the VGA output
on R-Car Gen3 platforms. That patch has already been approved, and I'll
get it merged as a prerequisite.

The series has been tested on the Renesas R-Car Salvator-XS and Draak
boards with the VGA, HDMI and LVDS outputs.

[1] https://lore.kernel.org/dri-devel/20200526011505.31884-28-laurent.pinchart+renesas@ideasonboard.com/

Laurent Pinchart (4):
  drm: rcar-du: lvds: Convert to DRM panel bridge helper
  drm: bridge: dw-hdmi: Attach to next bridge if available
  drm: rcar-du: dw-hdmi: Set output port number
  drm: rcar-du: Use drm_bridge_connector_init() helper

 drivers/gpu/drm/bridge/synopsys/dw-hdmi.c |  54 +++++++++-
 drivers/gpu/drm/rcar-du/rcar_du_encoder.c |  25 ++++-
 drivers/gpu/drm/rcar-du/rcar_dw_hdmi.c    |   1 +
 drivers/gpu/drm/rcar-du/rcar_lvds.c       | 120 +++-------------------
 include/drm/bridge/dw_hdmi.h              |   2 +
 5 files changed, 88 insertions(+), 114 deletions(-)