mbox series

[0/8] pinctrl: renesas: r8a779g0: Fix pin group suffixes

Message ID cover.1717754960.git.geert+renesas@glider.be (mailing list archive)
Headers show
Series pinctrl: renesas: r8a779g0: Fix pin group suffixes | expand

Message

Geert Uytterhoeven June 7, 2024, 10:13 a.m. UTC
Hi all,

On R-Car SoCs, pin group names usually have a suffix ("_a", "_b", ...)
if and only if there are alternate pin groups for the same function.
At the time initial pin control support for the R-Car V4H (R8A779G0) SoC
was introduced, there were lots of ambiguities and inconsistencies in
the naming of pin groups in the documentation, violating this convention:
  1. Some alternate pin groups may be named identically, without any
     suffix to differentiate,
  2. In case of two alternate pin groups, the primary may not carry a
     suffix, while the alternate may carry an "_a" or "_b" suffix,
  3. A pin group without an alternate may have an "_a" or even a "_b"
     suffix.
So far the driver followed the documentation, except for case 1, where
an "_x" suffix was added to one of the alternates.  The plan was to
update the pin group names when they were clarified in the documentation.
As technically these names are part of the ABI, they were clearly marked
with "suffix might be updated" in the driver.

Unfortunately the pin group names are still not updated in the latest
revision (Rev.1.10) of the R-Car V4H Series Hardware User's Manual.
However, the newer R-Car V4M (R8A779H0) SoC is mostly signal-compatible
with R-Car V4H (they are not pin-compatible, as R-Car V4H has many more
pins).  Hence this series bites the bullet, and fixes the ambiguities
and inconsistencies by adopting R-Car V4M pin group naming (from Rev.0.51
of the R-Car V4M Series Hardware User's Manual), and following the
traditional naming convention.

Note that this does not affect any upstream DTS files.

Thanks for your comments!

Geert Uytterhoeven (8):
  pinctrl: renesas: r8a779g0: Fix CANFD5 suffix
  pinctrl: renesas: r8a779g0: Fix FXR_TXEN[AB] suffixes
  pinctrl: renesas: r8a779g0: Fix (H)SCIF1 suffixes
  pinctrl: renesas: r8a779g0: Fix (H)SCIF3 suffixes
  pinctrl: renesas: r8a779g0: Fix IRQ suffixes
  pinctrl: renesas: r8a779g0: FIX PWM suffixes
  pinctrl: renesas: r8a779g0: Fix TCLK suffixes
  pinctrl: renesas: r8a779g0: Fix TPU suffixes

 drivers/pinctrl/renesas/pfc-r8a779g0.c | 712 ++++++++++++-------------
 1 file changed, 348 insertions(+), 364 deletions(-)

Comments

Geert Uytterhoeven June 24, 2024, 1:54 p.m. UTC | #1
On Fri, Jun 7, 2024 at 12:14 PM Geert Uytterhoeven
<geert+renesas@glider.be> wrote:
> On R-Car SoCs, pin group names usually have a suffix ("_a", "_b", ...)
> if and only if there are alternate pin groups for the same function.
> At the time initial pin control support for the R-Car V4H (R8A779G0) SoC
> was introduced, there were lots of ambiguities and inconsistencies in
> the naming of pin groups in the documentation, violating this convention:
>   1. Some alternate pin groups may be named identically, without any
>      suffix to differentiate,
>   2. In case of two alternate pin groups, the primary may not carry a
>      suffix, while the alternate may carry an "_a" or "_b" suffix,
>   3. A pin group without an alternate may have an "_a" or even a "_b"
>      suffix.
> So far the driver followed the documentation, except for case 1, where
> an "_x" suffix was added to one of the alternates.  The plan was to
> update the pin group names when they were clarified in the documentation.
> As technically these names are part of the ABI, they were clearly marked
> with "suffix might be updated" in the driver.
>
> Unfortunately the pin group names are still not updated in the latest
> revision (Rev.1.10) of the R-Car V4H Series Hardware User's Manual.
> However, the newer R-Car V4M (R8A779H0) SoC is mostly signal-compatible
> with R-Car V4H (they are not pin-compatible, as R-Car V4H has many more
> pins).  Hence this series bites the bullet, and fixes the ambiguities
> and inconsistencies by adopting R-Car V4M pin group naming (from Rev.0.51
> of the R-Car V4M Series Hardware User's Manual), and following the
> traditional naming convention.
>
> Note that this does not affect any upstream DTS files.
>
> Thanks for your comments!
>
> Geert Uytterhoeven (8):
>   pinctrl: renesas: r8a779g0: Fix CANFD5 suffix
>   pinctrl: renesas: r8a779g0: Fix FXR_TXEN[AB] suffixes
>   pinctrl: renesas: r8a779g0: Fix (H)SCIF1 suffixes
>   pinctrl: renesas: r8a779g0: Fix (H)SCIF3 suffixes
>   pinctrl: renesas: r8a779g0: Fix IRQ suffixes
>   pinctrl: renesas: r8a779g0: FIX PWM suffixes
>   pinctrl: renesas: r8a779g0: Fix TCLK suffixes
>   pinctrl: renesas: r8a779g0: Fix TPU suffixes

Unless someone objects, I plan to queue these in renesas-pinctrl for v6.11.

Gr{oetje,eeting}s,

                        Geert