@@ -160,11 +160,25 @@
sdhi0_pins: sd0 {
groups = "sdhi0_data4", "sdhi0_ctrl";
function = "sdhi0";
+ power-source = <3300>;
+ };
+
+ sdhi0_pins_uhs: sd0_uhs {
+ groups = "sdhi0_data4", "sdhi0_ctrl";
+ function = "sdhi0";
+ power-source = <1800>;
};
sdhi2_pins: sd2 {
groups = "sdhi2_data4", "sdhi2_ctrl";
function = "sdhi2";
+ power-source = <3300>;
+ };
+
+ sdhi2_pins_uhs: sd2_uhs {
+ groups = "sdhi2_data4", "sdhi2_ctrl";
+ function = "sdhi2";
+ power-source = <1800>;
};
qspi_pins: qspi {
@@ -238,22 +252,27 @@
&sdhi0 {
pinctrl-0 = <&sdhi0_pins>;
- pinctrl-names = "default";
+ pinctrl-1 = <&sdhi0_pins_uhs>;
+ pinctrl-names = "default", "state_uhs";
vmmc-supply = <&vcc_sdhi0>;
vqmmc-supply = <&vccq_sdhi0>;
cd-gpios = <&gpio6 6 GPIO_ACTIVE_LOW>;
wp-gpios = <&gpio6 7 GPIO_ACTIVE_HIGH>;
+ sd-uhs-sdr50;
+ sd-uhs-sdr104;
status = "okay";
};
&sdhi2 {
pinctrl-0 = <&sdhi2_pins>;
- pinctrl-names = "default";
+ pinctrl-1 = <&sdhi2_pins_uhs>;
+ pinctrl-names = "default", "state_uhs";
vmmc-supply = <&vcc_sdhi2>;
vqmmc-supply = <&vccq_sdhi2>;
cd-gpios = <&gpio6 22 GPIO_ACTIVE_LOW>;
+ sd-uhs-sdr50;
status = "okay";
};
Add the "1v8" pinctrl state and sd-uhs-sdr50 property to SDHI{0,2}. And the sd-uhs-sdr104 property to SDHI0. Signed-off-by: Simon Horman <horms+renesas@verge.net.au> -- Testing failed: - SDHI0: mmc0: error -110 whilst initialising SD card - It is unclear if this is something to do with my hardware/firmware environment or software problem. + SD card CID: 035344534c33324780aa9c34de010600 Untested: - SDHI2: Untested due to no card present in remotely accessed board --- arch/arm/boot/dts/r8a7791-porter.dts | 23 +++++++++++++++++++++-- 1 file changed, 21 insertions(+), 2 deletions(-)