@@ -99,7 +99,7 @@ properties:
multi-master:
type: boolean
description:
- States that there is another master active on this bus. The OS can use
+ States that there is another controller active on this bus. The OS can use
this information to adapt power management to keep the arbitration awake
all the time, for example. Can not be combined with 'single-master'.
@@ -116,9 +116,9 @@ properties:
single-master:
type: boolean
description:
- States that there is no other master active on this bus. The OS can use
- this information to detect a stalled bus more reliably, for example. Can
- not be combined with 'multi-master'.
+ States that there is no other controller active on this bus. The OS can
+ use this information to detect a stalled bus more reliably, for example.
+ Can not be combined with 'multi-master'.
smbus:
type: boolean
@@ -155,7 +155,7 @@ patternProperties:
- minimum: 0xc0000000
maximum: 0xc00003ff
description: |
- One or many I2C slave addresses. These are usually a 7 bit addresses.
+ One or many I2C target addresses. These are usually 7 bit addresses.
However, flags can be attached to an address. I2C_TEN_BIT_ADDRESS is
used to mark a 10 bit address. It is needed to avoid the ambiguity
between e.g. a 7 bit address of 0x50 and a 10 bit address of 0x050
@@ -172,7 +172,7 @@ patternProperties:
interrupts:
description:
I2C core will treat "irq" interrupt (or the very first interrupt if
- not using interrupt names) as primary interrupt for the slave.
+ not using interrupt names) as primary interrupt for the target.
interrupt-names:
anyOf:
Changing bindings is hard, changing descriptions is easy. Let's start with the low-hanging fruits and use the official I2C terminology (as of specs v7) in the descriptions. Drop a superfluous 'a' from the description of 'reg' for targets. Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com> --- dtschema/schemas/i2c/i2c-controller.yaml | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)