diff mbox series

[v2,8/8] arm64: dts: renesas: r9a09g047e57-smarc: Enable SDHI1

Message ID 20250131112429.119882-9-biju.das.jz@bp.renesas.com (mailing list archive)
State New
Delegated to: Geert Uytterhoeven
Headers show
Series Add RZ/G3E SDHI support | expand

Commit Message

Biju Das Jan. 31, 2025, 11:24 a.m. UTC 
Enable SDHI1 on the RZ/G3E SMARC EVK platform using gpio regulator for
voltage switching.

Signed-off-by: Biju Das <biju.das.jz@bp.renesas.com>
---
v1->v2:
 * Replaced the regulator usd_vdd_3p3v->reg_3p3v.
 * Renamed the gpio-hog node sd1-pwr-en->sd1-pwr-en-hog.
 * Sorted sd1 pin ctrl nodes.
---
 .../boot/dts/renesas/r9a09g047e57-smarc.dts   | 45 +++++++++++++++++++
 .../boot/dts/renesas/renesas-smarc2.dtsi      | 18 ++++++++
 2 files changed, 63 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/renesas/r9a09g047e57-smarc.dts b/arch/arm64/boot/dts/renesas/r9a09g047e57-smarc.dts
index fe67bce26d75..5d7983812c70 100644
--- a/arch/arm64/boot/dts/renesas/r9a09g047e57-smarc.dts
+++ b/arch/arm64/boot/dts/renesas/r9a09g047e57-smarc.dts
@@ -9,6 +9,7 @@ 
 
 /* Switch selection settings */
 #define SW_SD0_DEV_SEL		0
+#define SW_SDIO_M2E		0
 
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/pinctrl/renesas,r9a09g047-pinctrl.h>
@@ -20,6 +21,16 @@  / {
 	model = "Renesas SMARC EVK version 2 based on r9a09g047e57";
 	compatible = "renesas,smarc2-evk", "renesas,rzg3e-smarcm",
 		     "renesas,r9a09g047e57", "renesas,r9a09g047";
+
+	vqmmc_sd1_pvdd: regulator-vqmmc-sd1-pvdd {
+		compatible = "regulator-gpio";
+		regulator-name = "SD1_PVDD";
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <3300000>;
+		gpios = <&pinctrl RZG3E_GPIO(1, 5) GPIO_ACTIVE_HIGH>;
+		gpios-states = <0>;
+		states = <3300000 0>, <1800000 1>;
+	};
 };
 
 &pinctrl {
@@ -27,9 +38,43 @@  scif_pins: scif {
 		pins = "SCIF_TXD", "SCIF_RXD";
 		renesas,output-impedance = <1>;
 	};
+
+	sd1-pwr-en-hog {
+		gpio-hog;
+		gpios = <RZG3E_GPIO(1, 6) GPIO_ACTIVE_HIGH>;
+		output-high;
+		line-name = "sd1_pwr_en";
+	};
+
+	sdhi1_pins: sd1 {
+		sd1-cd {
+			pinmux = <RZG3E_PORT_PINMUX(1, 4, 8)>; /* SD1CD */
+		};
+
+		sd1-ctrl {
+			pinmux = <RZG3E_PORT_PINMUX(G, 0, 1)>, /* SD1CLK */
+				 <RZG3E_PORT_PINMUX(G, 1, 1)>; /* SD1CMD */
+		};
+
+		sd1-data {
+			pinmux = <RZG3E_PORT_PINMUX(G, 2, 1)>, /* SD1DAT0 */
+				 <RZG3E_PORT_PINMUX(G, 3, 1)>, /* SD1DAT1 */
+				 <RZG3E_PORT_PINMUX(G, 4, 1)>, /* SD1DAT2 */
+				 <RZG3E_PORT_PINMUX(G, 5, 1)>; /* SD1DAT3 */
+		};
+	};
 };
 
 &scif0 {
 	pinctrl-0 = <&scif_pins>;
 	pinctrl-names = "default";
 };
+
+&sdhi1 {
+	pinctrl-0 = <&sdhi1_pins>;
+	pinctrl-1 = <&sdhi1_pins>;
+	pinctrl-names = "default", "state_uhs";
+
+	vmmc-supply = <&reg_3p3v>;
+	vqmmc-supply = <&vqmmc_sd1_pvdd>;
+};
diff --git a/arch/arm64/boot/dts/renesas/renesas-smarc2.dtsi b/arch/arm64/boot/dts/renesas/renesas-smarc2.dtsi
index e378d55e6e9b..fd82df8adc1e 100644
--- a/arch/arm64/boot/dts/renesas/renesas-smarc2.dtsi
+++ b/arch/arm64/boot/dts/renesas/renesas-smarc2.dtsi
@@ -5,6 +5,15 @@ 
  * Copyright (C) 2024 Renesas Electronics Corp.
  */
 
+/*
+ * Please set the switch position SW_OPT_MUX.1 on the carrier board and the
+ * corresponding macro SW_SDIO_M2E on the board DTS:
+ *
+ * SW_SDIO_M2E:
+ *     0 - SMARC SDIO signal is connected to uSD1
+ *     1 - SMARC SDIO signal is connected to M.2 Key E connector
+ */
+
 / {
 	model = "Renesas RZ SMARC Carrier-II Board";
 	compatible = "renesas,smarc2-evk";
@@ -16,9 +25,18 @@  chosen {
 
 	aliases {
 		serial3 = &scif0;
+		mmc1 = &sdhi1;
 	};
 };
 
 &scif0 {
 	status = "okay";
 };
+
+&sdhi1 {
+	bus-width = <4>;
+	sd-uhs-sdr50;
+	sd-uhs-sdr104;
+
+	status = "okay";
+};