@@ -340,42 +340,43 @@
leds {
compatible = "gpio-leds";
- user_led4 {
- label = "user_led4";
+
+ user_led1 {
+ label = "green:user1";
gpios = <&gpio4 0 0>; /* <&gpio_user_led_1>; */
linux,default-trigger = "heartbeat";
};
- user_led3 {
- label = "user_led3";
+ user_led2 {
+ label = "green:user2";
gpios = <&gpio4 1 0>; /* <&gpio_user_led_2>; */
linux,default-trigger = "mmc0";
};
- user_led2 {
- label = "user_led2";
+ user_led3 {
+ label = "green:user3";
gpios = <&gpio4 2 0>; /* <&gpio_user_led_3>; */
linux,default-trigger = "mmc1";
};
- user_led1 {
- label = "user_led1";
+ user_led4 {
+ label = "green:user4";
gpios = <&gpio4 3 0>; /* <&gpio_user_led_4>; */
panic-indicator;
- linux,default-trigger = "cpu0";
+ linux,default-trigger = "none";
};
wlan_active_led {
- label = "wifi_active";
+ label = "yellow:wlan";
gpios = <&gpio3 5 0>; /* <&gpio_wlan_active_led>; */
linux,default-trigger = "phy0tx";
default-state = "off";
};
bt_active_led {
- label = "bt_active";
+ label = "blue:bt";
gpios = <&gpio4 7 0>; /* <&gpio_bt_active_led>; */
- linux,default-trigger = "hci0rx";
+ linux,default-trigger = "hci0-power";
default-state = "off";
};
};
For all 96Boards, the following standard is used for onboard LEDs. green:user1 default-trigger: heartbeat green:user2 default-trigger: mmc0/disk-activity(onboard-storage) green:user3 default-trigger: mmc1 (SD-card) green:user4 default-trigger: none, panic-indicator yellow:wlan default-trigger: phy0tx blue:bt default-trigger: hci0-power So lets adopt the same for HiKey, which is one of the 96Boards CE platform. Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> --- .../arm64/boot/dts/hisilicon/hi6220-hikey.dts | 25 ++++++++++--------- 1 file changed, 13 insertions(+), 12 deletions(-)