diff mbox series

[7/8] arm64: dts: zynqmp-zcu100-revC: Correct interrupt flags in examples

Message ID 20200908150241.5771-7-krzk@kernel.org (mailing list archive)
State New, archived
Headers show
Series [1/8] ARM: dts: imx6qdl: Correct interrupt flags in examples | expand

Commit Message

Krzysztof Kozlowski Sept. 8, 2020, 3:02 p.m. UTC
GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING

Correct the interrupt flags, assuming the author of the code wanted some
logical behavior behind the name "ACTIVE_xxx", this is:
  ACTIVE_LOW => IRQ_TYPE_LEVEL_LOW

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>

---

Not tested on HW.
---
 arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
index d60110ad8367..c9460693f4e9 100644
--- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
+++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
@@ -186,7 +186,7 @@ 
 				compatible = "ti,tps65086";
 				reg = <0x5e>;
 				interrupt-parent = <&gpio>;
-				interrupts = <77 GPIO_ACTIVE_LOW>;
+				interrupts = <77 IRQ_TYPE_LEVEL_LOW>;
 				#gpio-cells = <2>;
 				gpio-controller;
 			};