@@ -126,7 +126,9 @@ struct dw_hdmi {
bool sink_has_audio;
struct mutex mutex; /* for state below and previous_mode */
+ enum drm_connector_force force; /* mutex-protected force state */
bool disabled; /* DRM has disabled our bridge */
+ bool bridge_is_on; /* indicates the bridge is on */
spinlock_t audio_lock;
struct mutex audio_mutex;
@@ -1378,12 +1380,36 @@ static void initialize_hdmi_ih_mutes(struct dw_hdmi *hdmi)
static void dw_hdmi_poweron(struct dw_hdmi *hdmi)
{
+ hdmi->bridge_is_on = true;
dw_hdmi_setup(hdmi, &hdmi->previous_mode);
}
static void dw_hdmi_poweroff(struct dw_hdmi *hdmi)
{
dw_hdmi_phy_disable(hdmi);
+ hdmi->bridge_is_on = false;
+}
+
+static void dw_hdmi_update_power(struct dw_hdmi *hdmi)
+{
+ int force = hdmi->force;
+
+ if (hdmi->disabled) {
+ force = DRM_FORCE_OFF;
+ } else if (force == DRM_FORCE_UNSPECIFIED) {
+ if (hdmi_readb(hdmi, HDMI_PHY_STAT0) & HDMI_PHY_HPD)
+ force = DRM_FORCE_ON;
+ else
+ force = DRM_FORCE_OFF;
+ }
+
+ if (force == DRM_FORCE_OFF) {
+ if (hdmi->bridge_is_on)
+ dw_hdmi_poweroff(hdmi);
+ } else {
+ if (!hdmi->bridge_is_on)
+ dw_hdmi_poweron(hdmi);
+ }
}
static void dw_hdmi_bridge_mode_set(struct drm_bridge *bridge,
@@ -1413,7 +1439,7 @@ static void dw_hdmi_bridge_disable(struct drm_bridge *bridge)
mutex_lock(&hdmi->mutex);
hdmi->disabled = true;
- dw_hdmi_poweroff(hdmi);
+ dw_hdmi_update_power(hdmi);
mutex_unlock(&hdmi->mutex);
}
@@ -1422,8 +1448,8 @@ static void dw_hdmi_bridge_enable(struct drm_bridge *bridge)
struct dw_hdmi *hdmi = bridge->driver_private;
mutex_lock(&hdmi->mutex);
- dw_hdmi_poweron(hdmi);
hdmi->disabled = false;
+ dw_hdmi_update_power(hdmi);
mutex_unlock(&hdmi->mutex);
}
@@ -1438,6 +1464,11 @@ dw_hdmi_connector_detect(struct drm_connector *connector, bool force)
struct dw_hdmi *hdmi = container_of(connector, struct dw_hdmi,
connector);
+ mutex_lock(&hdmi->mutex);
+ hdmi->force = DRM_FORCE_UNSPECIFIED;
+ dw_hdmi_update_power(hdmi);
+ mutex_unlock(&hdmi->mutex);
+
return hdmi_readb(hdmi, HDMI_PHY_STAT0) & HDMI_PHY_HPD ?
connector_status_connected : connector_status_disconnected;
}
@@ -1502,11 +1533,23 @@ static void dw_hdmi_connector_destroy(struct drm_connector *connector)
drm_connector_cleanup(connector);
}
+static void dw_hdmi_connector_force(struct drm_connector *connector)
+{
+ struct dw_hdmi *hdmi = container_of(connector, struct dw_hdmi,
+ connector);
+
+ mutex_lock(&hdmi->mutex);
+ hdmi->force = connector->force;
+ dw_hdmi_update_power(hdmi);
+ mutex_unlock(&hdmi->mutex);
+}
+
static struct drm_connector_funcs dw_hdmi_connector_funcs = {
.dpms = drm_helper_connector_dpms,
.fill_modes = drm_helper_probe_single_connector_modes,
.detect = dw_hdmi_connector_detect,
.destroy = dw_hdmi_connector_destroy,
+ .force = dw_hdmi_connector_force,
};
static struct drm_connector_helper_funcs dw_hdmi_connector_helper_funcs = {
@@ -1552,12 +1595,12 @@ static irqreturn_t dw_hdmi_irq(int irq, void *dev_id)
if (phy_int_pol & HDMI_PHY_HPD) {
dev_dbg(hdmi->dev, "EVENT=plugin\n");
- if (!hdmi->disabled)
+ if (!hdmi->disabled && !hdmi->force)
dw_hdmi_poweron(hdmi);
} else {
dev_dbg(hdmi->dev, "EVENT=plugout\n");
- if (!hdmi->disabled)
+ if (!hdmi->disabled && !hdmi->force)
dw_hdmi_poweroff(hdmi);
}
mutex_unlock(&hdmi->mutex);
When connected to HDMI sources, some DVI monitors de-assert their HPD signal and TDMS loads for one seconds every four seconds when there is no signal present on the connection. Unfortunately, this behaviour is indistinguishable from a proper HDMI setup with an AV receiver in the path to the display: the HDMI spec requires us to detect HPD deassertions as short as 100ms, which indicate that the EDID has changed. Since it is possible to connect a DVI monitor to an AV receiver and then to a HDMI source, merely working around this by detecting the lack of HDMI vendor block in the EDID is insufficient - the AV receiver is at liberty to modify the EDID as it sees fit, and it will place its own parameters into the EDID including the HDMI vendor block. DRM has support for forcing the state of a connector, which we should implement to allow us to work around these broken DVI monitors - we can tell DRM to force the connection state to indicate that there is always a device connected to work around this problem. Although this requires manual configuration, it is better than nothing at all. When a forced connection state has been set, there is no point handling our RXSENSE interrupts, so disable them in this circumstance. Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk> --- drivers/gpu/drm/bridge/dw_hdmi.c | 51 ++++++++++++++++++++++++++++++++++++---- 1 file changed, 47 insertions(+), 4 deletions(-)