mbox series

[00/16] clk: samsung: Add CPU clocks for Exynos850

Message ID 20240216223245.12273-1-semen.protsenko@linaro.org (mailing list archive)
Headers show
Series clk: samsung: Add CPU clocks for Exynos850 | expand

Message

Sam Protsenko Feb. 16, 2024, 10:32 p.m. UTC
The series implements CPU clock support for Exynos850, adds CPU CMUs to
the clock driver and enables those in dts. This is the first step
towards cpufreq implementation.

The breakup by patch:

  * Patch 01: Add bindings
  * Patches 02..12: Prepare clk-cpu.c for Exynos850 support
  * Patch 13: Add Exynos850 support
  * Patch 14: Init PLLs to be in manual mode
  * Patch 15: Add CPU CMUs in Exynos850 clock driver
  * Patch 16: Add CPU CMUs and clocks in Exynos850 dtsi

If possible, all patches should go through Krzysztof's tree. As
inter-series dependencies go:

  * All driver changes (patch 02..15) must be taken together following
    the order established in this series
  * Patch 16 (dts changes) depends on patch 01 (bindings additions)
  * Patch 15 (driver changes) depends on patch 01 (bindings additions)

The series was tested on E850-96 board, via DebugFS with
CLOCK_ALLOW_WRITE_DEBUGFS enabled, by setting different CPU clock rates,
like this:

  # cd /sys/kernel/debug/clk/cluster0_clk/
  # cat clk_rate
  1053000000
  # echo 10000000 > clk_rate
  # cat clk_rate
  130000000

Of course, DVFS/cpufreq is not implemented yet, so the CPU can't be
overclocked too much right now, and the cpufreq interface is not
available too. As per the TRM, the CPU operates at a voltage level of
0.65 V, 0.75 V, 0.85 V and 1.05 V. When the voltage is 0.85 V, A55
quad-core operates at 1.6 GHz and CoreSight at 200 MHz.

To check the actual frequency, the "perf" tool was used:

  # perf stat sleep 1

And to check that on a particular CPU core:

  # taskset -c 4 perf stat sleep 1

Some takeaways:

  * Max functional frequency right now is 1.586 GHz
  * 1.742 GHz or more leads to the system freeze, as it requires
    more voltage to be operational
  * Max possible frequency: 2.210 GHz
  * The lowest possible frequency: 130 MHz
  * Default boot up frequency: 1.053 GHz

Sam Protsenko (16):
  dt-bindings: clock: exynos850: Add CMU_CPUCLK0 and CMU_CPUCL1
  clk: samsung: Improve clk-cpu.c style
  clk: samsung: Pull struct exynos_cpuclk into clk-cpu.c
  clk: samsung: Reduce params count in exynos_register_cpu_clock()
  clk: samsung: Use single CPU clock notifier callback for all chips
  clk: samsung: Group CPU clock functions by chip
  clk: samsung: Pass actual clock controller base address to CPU_CLK()
  clk: samsung: Use clk.h as a single header for Samsung CCF
  clk: samsung: Pass register layout type explicitly to CLK_CPU()
  clk: samsung: Keep CPU clock chip specific data in a dedicated struct
  clk: samsung: Keep register offsets in chip specific structure
  clk: samsung: Pass mask to wait_until_mux_stable()
  clk: samsung: Add CPU clock support for Exynos850
  clk: samsung: Implement manual PLL control for ARM64 SoCs
  clk: samsung: exynos850: Add CMU_CPUCL0 and CMU_CPUCL1
  arm64: dts: exynos: Add CPU clocks

 .../clock/samsung,exynos850-clock.yaml        |  42 ++
 arch/arm64/boot/dts/exynos/exynos850.dtsi     |  26 +
 drivers/clk/samsung/clk-cpu.c                 | 565 +++++++++++++-----
 drivers/clk/samsung/clk-cpu.h                 |  53 +-
 drivers/clk/samsung/clk-exynos-arm64.c        |  44 +-
 drivers/clk/samsung/clk-exynos3250.c          |   4 +-
 drivers/clk/samsung/clk-exynos4.c             |  10 +-
 drivers/clk/samsung/clk-exynos5250.c          |   6 +-
 drivers/clk/samsung/clk-exynos5260.c          |   1 -
 drivers/clk/samsung/clk-exynos5420.c          |  17 +-
 drivers/clk/samsung/clk-exynos5433.c          |  12 +-
 drivers/clk/samsung/clk-exynos850.c           | 440 +++++++++++++-
 drivers/clk/samsung/clk-pll.c                 |   2 +-
 drivers/clk/samsung/clk-s3c64xx.c             |   1 -
 drivers/clk/samsung/clk-s5pv210.c             |   1 -
 drivers/clk/samsung/clk.h                     |   9 +-
 include/dt-bindings/clock/exynos850.h         |  54 ++
 17 files changed, 1042 insertions(+), 245 deletions(-)

Comments

Krzysztof Kozlowski Feb. 20, 2024, 11:07 a.m. UTC | #1
On 16/02/2024 23:32, Sam Protsenko wrote:
> The series implements CPU clock support for Exynos850, adds CPU CMUs to
> the clock driver and enables those in dts. This is the first step
> towards cpufreq implementation.
> 
> The breakup by patch:
> 
>   * Patch 01: Add bindings
>   * Patches 02..12: Prepare clk-cpu.c for Exynos850 support
>   * Patch 13: Add Exynos850 support
>   * Patch 14: Init PLLs to be in manual mode
>   * Patch 15: Add CPU CMUs in Exynos850 clock driver
>   * Patch 16: Add CPU CMUs and clocks in Exynos850 dtsi

This crossed the threshold for a patch bomb, which is in general fine
for me, but then please put v2 changelog in each patch's changelog. If
the patch did not change, annotate it as well. It's not possible to keep
jumping between cover letter and individual patches.

Best regards,
Krzysztof
Sam Protsenko Feb. 21, 2024, 11:07 p.m. UTC | #2
On Tue, Feb 20, 2024 at 5:07 AM Krzysztof Kozlowski
<krzysztof.kozlowski@linaro.org> wrote:
>
> On 16/02/2024 23:32, Sam Protsenko wrote:
> > The series implements CPU clock support for Exynos850, adds CPU CMUs to
> > the clock driver and enables those in dts. This is the first step
> > towards cpufreq implementation.
> >
> > The breakup by patch:
> >
> >   * Patch 01: Add bindings
> >   * Patches 02..12: Prepare clk-cpu.c for Exynos850 support
> >   * Patch 13: Add Exynos850 support
> >   * Patch 14: Init PLLs to be in manual mode
> >   * Patch 15: Add CPU CMUs in Exynos850 clock driver
> >   * Patch 16: Add CPU CMUs and clocks in Exynos850 dtsi
>
> This crossed the threshold for a patch bomb, which is in general fine
> for me, but then please put v2 changelog in each patch's changelog. If
> the patch did not change, annotate it as well. It's not possible to keep
> jumping between cover letter and individual patches.
>

The above list is not a change log, I just tried to show that patches
02..12 are cleanups. I'll reword this in v2 to make it less confusing.
And as usual I'll keep the changelog for each patch separately. Thanks
for the review!

> Best regards,
> Krzysztof
>
Krzysztof Kozlowski Feb. 22, 2024, 7:45 a.m. UTC | #3
On 22/02/2024 00:07, Sam Protsenko wrote:
> On Tue, Feb 20, 2024 at 5:07 AM Krzysztof Kozlowski
> <krzysztof.kozlowski@linaro.org> wrote:
>>
>> On 16/02/2024 23:32, Sam Protsenko wrote:
>>> The series implements CPU clock support for Exynos850, adds CPU CMUs to
>>> the clock driver and enables those in dts. This is the first step
>>> towards cpufreq implementation.
>>>
>>> The breakup by patch:
>>>
>>>   * Patch 01: Add bindings
>>>   * Patches 02..12: Prepare clk-cpu.c for Exynos850 support
>>>   * Patch 13: Add Exynos850 support
>>>   * Patch 14: Init PLLs to be in manual mode
>>>   * Patch 15: Add CPU CMUs in Exynos850 clock driver
>>>   * Patch 16: Add CPU CMUs and clocks in Exynos850 dtsi
>>
>> This crossed the threshold for a patch bomb, which is in general fine
>> for me, but then please put v2 changelog in each patch's changelog. If
>> the patch did not change, annotate it as well. It's not possible to keep
>> jumping between cover letter and individual patches.
>>
> 
> The above list is not a change log, I just tried to show that patches
> 02..12 are cleanups. I'll reword this in v2 to make it less confusing.
> And as usual I'll keep the changelog for each patch separately. Thanks
> for the review!

I know. I just wanted to clarify my expectations for v2.

Best regards,
Krzysztof