| Message ID | 1376522821-16133-1-git-send-email-broonie@kernel.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On 08/15/13 08:27, Mark Brown wrote: > From: Mark Brown<broonie@linaro.org> > > The Arndale has a SMSC USB3503 connected in hardware only mode like a PHY, > support it using the usb-nop-xceiv binding. > > Note that due to a regrettable decision to use a regulator to represent > the reset signal this uses a fixed voltage regulator to do that, there > is a plan to use the reset controller binding once that is merged so it > does not seem worthwhile to fix the usb-nop-xceiv driver at this point. > > Signed-off-by: Mark Brown<broonie@linaro.org> > Tested-by: Tushar Behera<tushar.behera@linaro.org> > --- > arch/arm/boot/dts/exynos5250-arndale.dts | 14 ++++++++++++++ > 1 file changed, 14 insertions(+) > > diff --git a/arch/arm/boot/dts/exynos5250-arndale.dts b/arch/arm/boot/dts/exynos5250-arndale.dts > index 96d528d..2428ffd 100644 > --- a/arch/arm/boot/dts/exynos5250-arndale.dts > +++ b/arch/arm/boot/dts/exynos5250-arndale.dts > @@ -539,4 +539,18 @@ > rtc { > status = "okay"; > }; > + > + usb_hub_bus { > + compatible = "simple-bus"; > + #address-cells =<1>; > + #size-cells =<0>; > + > + // SMSC USB3503 connected in hardware only mode as a PHY > + usb_hub: usb_hub { > + compatible = "smsc,usb3503a"; > + > + reset-gpios =<&gpx3 5 1>; > + connect-gpios =<&gpd1 7 1>; > + }; > + }; > }; Applied, thanks. Kukjin -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/arch/arm/boot/dts/exynos5250-arndale.dts b/arch/arm/boot/dts/exynos5250-arndale.dts index 96d528d..2428ffd 100644 --- a/arch/arm/boot/dts/exynos5250-arndale.dts +++ b/arch/arm/boot/dts/exynos5250-arndale.dts @@ -539,4 +539,18 @@ rtc { status = "okay"; }; + + usb_hub_bus { + compatible = "simple-bus"; + #address-cells = <1>; + #size-cells = <0>; + + // SMSC USB3503 connected in hardware only mode as a PHY + usb_hub: usb_hub { + compatible = "smsc,usb3503a"; + + reset-gpios = <&gpx3 5 1>; + connect-gpios = <&gpd1 7 1>; + }; + }; };