diff mbox

[RFC,v2,12/13] ARM: dts: exynos: Switch the buck8 to GPIO mode on Odroid U3

Message ID 1462451666-17945-13-git-send-email-k.kozlowski@samsung.com (mailing list archive)
State Not Applicable
Headers show

Commit Message

Krzysztof Kozlowski May 5, 2016, 12:34 p.m. UTC
Switch the control of buck8 to GPIO mode. It is faster than I2C/register
mode and it is the easiest way to disable it (regulator state is a
logical OR state of GPIO and register value).

Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
---
 arch/arm/boot/dts/exynos4412-odroidu3.dts | 1 +
 1 file changed, 1 insertion(+)

Comments

Javier Martinez Canillas May 5, 2016, 8:11 p.m. UTC | #1
Hello Krzysztof,

On 05/05/2016 08:34 AM, Krzysztof Kozlowski wrote:
> Switch the control of buck8 to GPIO mode. It is faster than I2C/register
> mode and it is the easiest way to disable it (regulator state is a
> logical OR state of GPIO and register value).
> 
> Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
> ---

Reviewed-by: Javier Martinez Canillas <javier@osg.samsung.com>

Best regards,
diff mbox

Patch

diff --git a/arch/arm/boot/dts/exynos4412-odroidu3.dts b/arch/arm/boot/dts/exynos4412-odroidu3.dts
index d73aa6c58fe3..31cdc036fda4 100644
--- a/arch/arm/boot/dts/exynos4412-odroidu3.dts
+++ b/arch/arm/boot/dts/exynos4412-odroidu3.dts
@@ -74,6 +74,7 @@ 
 	regulator-name = "BUCK8_P3V3";
 	regulator-min-microvolt = <3300000>;
 	regulator-max-microvolt = <3300000>;
+	maxim,ena-gpios = <&gpa1 1 GPIO_ACTIVE_HIGH>;
 };
 
 /* VDDQ for MSHC (eMMC card) */