@@ -5,7 +5,6 @@ Required properties:
- compatible : "samsung,exynos5433-lpass"
- reg : should contain the LPASS top SFR region location
and size
- - samsung,pmu-syscon : the phandle to the Power Management Unit node
- #address-cells : should be 1
- #size-cells : should be 1
- ranges : must be present
@@ -25,7 +24,6 @@ Example:
audio-subsystem {
compatible = "samsung,exynos5433-lpass";
reg = <0x11400000 0x100>, <0x11500000 0x08>;
- samsung,pmu-syscon = <&pmu_system_controller>;
#address-cells = <1>;
#size-cells = <1>;
ranges;
@@ -18,7 +18,6 @@
#include <linux/io.h>
#include <linux/module.h>
#include <linux/mfd/syscon.h>
-#include <linux/mfd/syscon/exynos5-pmu.h>
#include <linux/of.h>
#include <linux/of_platform.h>
#include <linux/platform_device.h>
@@ -51,8 +50,6 @@
#define LPASS_INTR_SFR BIT(0)
struct exynos_lpass {
- /* pointer to the Power Management Unit regmap */
- struct regmap *pmu;
/* pointer to the LPASS TOP regmap */
struct regmap *top;
};
@@ -81,10 +78,6 @@ static void exynos_lpass_enable(struct exynos_lpass *lpass)
regmap_write(lpass->top, SFR_LPASS_INTR_CPU_MASK,
LPASS_INTR_SFR | LPASS_INTR_DMA | LPASS_INTR_I2S);
- /* Activate related PADs from retention state */
- regmap_write(lpass->pmu, EXYNOS5433_PAD_RETENTION_AUD_OPTION,
- EXYNOS5433_PAD_INITIATE_WAKEUP_FROM_LOWPWR);
-
exynos_lpass_core_sw_reset(lpass, LPASS_I2S_SW_RESET);
exynos_lpass_core_sw_reset(lpass, LPASS_DMA_SW_RESET);
exynos_lpass_core_sw_reset(lpass, LPASS_MEM_SW_RESET);
@@ -95,9 +88,6 @@ static void exynos_lpass_disable(struct exynos_lpass *lpass)
/* Mask any unmasked IP interrupt sources */
regmap_write(lpass->top, SFR_LPASS_INTR_CPU_MASK, 0);
regmap_write(lpass->top, SFR_LPASS_INTR_CA5_MASK, 0);
-
- /* Deactivate related PADs from retention state */
- regmap_write(lpass->pmu, EXYNOS5433_PAD_RETENTION_AUD_OPTION, 0);
}
static const struct regmap_config exynos_lpass_reg_conf = {
@@ -131,13 +121,6 @@ static int exynos_lpass_probe(struct platform_device *pdev)
return PTR_ERR(lpass->top);
}
- lpass->pmu = syscon_regmap_lookup_by_phandle(dev->of_node,
- "samsung,pmu-syscon");
- if (IS_ERR(lpass->pmu)) {
- dev_err(dev, "Failed to lookup PMU regmap\n");
- return PTR_ERR(lpass->pmu);
- }
-
platform_set_drvdata(pdev, lpass);
exynos_lpass_enable(lpass);
@@ -46,7 +46,4 @@
#define EXYNOS5_MIPI_PHY_S_RESETN BIT(1)
#define EXYNOS5_MIPI_PHY_M_RESETN BIT(2)
-#define EXYNOS5433_PAD_RETENTION_AUD_OPTION (0x3028)
-#define EXYNOS5433_PAD_INITIATE_WAKEUP_FROM_LOWPWR BIT(28)
-
#endif /* _LINUX_MFD_SYSCON_PMU_EXYNOS5_H_ */
Pad retention should be controlled from pin control driver, so remove it from Exynos LPASS driver. After this change, no more access to PMU regmap is needed, so remove also the code for handling PMU regmap. Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com> --- .../bindings/mfd/samsung,exynos5433-lpass.txt | 2 -- drivers/mfd/exynos-lpass.c | 17 ----------------- include/linux/mfd/syscon/exynos5-pmu.h | 3 --- 3 files changed, 22 deletions(-)