diff mbox series

[V2,09/16] smartpqi: stop logging spurious PQI reset failures

Message ID 165730605108.177165.1132931838384767071.stgit@brunhilda (mailing list archive)
State Accepted
Headers show
Series smartpqi updates | expand

Commit Message

Don Brace July 8, 2022, 6:47 p.m. UTC 
From: Kevin Barnett <kevin.barnett@microchip.com>

Change method used to detect controller firmware crash during PQI reset.

PQI reset can fail with error -6 if firmware takes > 100ms to complete
reset.

Method used by driver to detect controller firmware crash during PQI
was incorrect in some cases.

Reviewed-by: Scott Benesh <scott.benesh@microchip.com>
Reviewed-by: Scott Teel <scott.teel@microchip.com>
Reviewed-by: Mike McGowen <mike.mcgowen@microchip.com>
Signed-off-by: Kevin Barnett <kevin.barnett@microchip.com>
Signed-off-by: Don Brace <don.brace@microchip.com>
---
 drivers/scsi/smartpqi/smartpqi_init.c |    3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/drivers/scsi/smartpqi/smartpqi_init.c b/drivers/scsi/smartpqi/smartpqi_init.c
index 77a8e0ed91a8..96b206ab5ecf 100644
--- a/drivers/scsi/smartpqi/smartpqi_init.c
+++ b/drivers/scsi/smartpqi/smartpqi_init.c
@@ -7412,8 +7412,7 @@  static int pqi_wait_for_pqi_reset_completion(struct pqi_ctrl_info *ctrl_info)
 		reset_reg.all_bits = readl(&pqi_registers->device_reset);
 		if (reset_reg.bits.reset_action == PQI_RESET_ACTION_COMPLETED)
 			break;
-		pqi_check_ctrl_health(ctrl_info);
-		if (pqi_ctrl_offline(ctrl_info)) {
+		if (!sis_is_firmware_running(ctrl_info)) {
 			rc = -ENXIO;
 			break;
 		}