@@ -911,8 +911,28 @@ static void hisi_sas_phyup_work_common(struct work_struct *work,
container_of(work, typeof(*phy), works[event]);
struct hisi_hba *hisi_hba = phy->hisi_hba;
struct asd_sas_phy *sas_phy = &phy->sas_phy;
+ struct asd_sas_port *sas_port = sas_phy->port;
+ struct hisi_sas_port *port = phy->port;
+ struct device *dev = hisi_hba->dev;
+ struct domain_device *port_dev;
int phy_no = sas_phy->id;
+ if (!test_bit(HISI_SAS_RESETTING_BIT, &hisi_hba->flags) &&
+ sas_port && port && (port->id != phy->port_id)) {
+ dev_info(dev, "phy%d's hw port id changed from %d to %llu\n",
+ phy_no, port->id, phy->port_id);
+ port_dev = sas_port->port_dev;
+ if (port_dev && !dev_is_expander(port_dev->dev_type)) {
+ /*
+ * Set the device state to gone to block
+ * sending IO to the device.
+ */
+ set_bit(SAS_DEV_GONE, &port_dev->state);
+ hisi_sas_notify_phy_event(phy, HISI_PHYE_LINK_RESET);
+ return;
+ }
+ }
+
phy->wait_phyup_cnt = 0;
if (phy->identify.target_port_protocols == SAS_PROTOCOL_SSP)
hisi_hba->hw->sl_notify_ssp(hisi_hba, phy_no);
The hw port id of phy may change when inserting disks in batches, causing the port id in hisi_sas_port and itct to be inconsistent with the hardware, resulting in IO errors. The solution is to set the device state to gone to intercept IO sent to the device, and then execute linkreset to discard and find the disk to re-update its information. Signed-off-by: Xingui Yang <yangxingui@huawei.com> --- drivers/scsi/hisi_sas/hisi_sas_main.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)