@@ -2023,8 +2023,6 @@ static void NCR5380_reselect(struct Scsi_Host *instance)
return;
}
- dsprintk(NDEBUG_RESELECTION, instance, "reselect\n");
-
/*
* At this point, we have detected that our SCSI ID is on the bus,
* SEL is true and BSY was false for at least one bus settle delay
@@ -2037,6 +2035,7 @@ static void NCR5380_reselect(struct Scsi_Host *instance)
NCR5380_write(INITIATOR_COMMAND_REG, ICR_BASE | ICR_ASSERT_BSY);
if (NCR5380_poll_politely(hostdata,
STATUS_REG, SR_SEL, 0, 2 * HZ) < 0) {
+ shost_printk(KERN_ERR, instance, "reselect: !SEL timeout\n");
NCR5380_write(INITIATOR_COMMAND_REG, ICR_BASE);
return;
}
@@ -2048,6 +2047,7 @@ static void NCR5380_reselect(struct Scsi_Host *instance)
if (NCR5380_poll_politely(hostdata,
STATUS_REG, SR_REQ, SR_REQ, 2 * HZ) < 0) {
+ shost_printk(KERN_ERR, instance, "reselect: REQ timeout\n");
do_abort(instance);
return;
}
The X3T9.2 specification (draft) says, under "6.1.4.1 RESELECTION", ... The reselected initiator shall then assert the BSY signal within a selection abort time of its most recent detection of being reselected; this is required for correct operation of the time-out procedure. The selection abort time is only 200 us which may be insufficient time for a printk() call. Move the diagnostics to the error paths. Tested-by: Michael Schmitz <schmitzmic@gmail.com> Signed-off-by: Finn Thain <fthain@telegraphics.com.au> --- drivers/scsi/NCR5380.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)