@@ -1,7 +1,10 @@
* Renesas R-Car SATA
Required properties:
-- compatible : should contain "renesas,sata-r8a7779";
+- compatible : should contain one of the following:
+ - "renesas,sata-r8a7779" for R-Car H1
+ - "renesas,sata-r8a7790" for R-Car H2
+ - "renesas,sata-r8a7791" for R-Car M2
- reg : offset and length of the SATA registers;
- interrupts : must consist of one interrupt specifier.
@@ -170,7 +170,7 @@ static struct clk_lookup lookups[] = {
/* MSTP32 clocks */
CLKDEV_DEV_ID("r8a7779-vin.3", &mstp_clks[MSTP120]), /* VIN3 */
CLKDEV_DEV_ID("rcar-pcie", &mstp_clks[MSTP116]), /* PCIe */
- CLKDEV_DEV_ID("sata_rcar", &mstp_clks[MSTP115]), /* SATA */
+ CLKDEV_DEV_ID("sata-r8a7779", &mstp_clks[MSTP115]), /* SATA */
CLKDEV_DEV_ID("fc600000.sata", &mstp_clks[MSTP115]), /* SATA w/DT */
CLKDEV_DEV_ID("r8a777x-ether", &mstp_clks[MSTP114]), /* Ether */
CLKDEV_DEV_ID("r8a7779-vin.0", &mstp_clks[MSTP110]), /* VIN0 */
@@ -438,7 +438,7 @@ static struct resource sata_resources[] = {
};
static struct platform_device sata_device = {
- .name = "sata_rcar",
+ .name = "sata-r8a7779",
.id = -1,
.resource = sata_resources,
.num_resources = ARRAY_SIZE(sata_resources),
@@ -15,6 +15,7 @@
#include <linux/module.h>
#include <linux/ata.h>
#include <linux/libata.h>
+#include <linux/of_device.h>
#include <linux/platform_device.h>
#include <linux/clk.h>
#include <linux/err.h>
@@ -123,12 +124,37 @@
#define SATA_RCAR_DMA_BOUNDARY 0x1FFFFFFEUL
+/* Gen2 Physical Layer Control Registers */
+#define RCAR_GEN2_PHY_CTL1_REG 0x1704
+#define RCAR_GEN2_PHY_CTL1 0x34180002
+#define RCAR_GEN2_PHY_CTL1_SS 0xC180 /* Spread Spectrum */
+
+#define RCAR_GEN2_PHY_CTL2_REG 0x170C
+#define RCAR_GEN2_PHY_CTL2 0x00002303
+
+#define RCAR_GEN2_PHY_CTL3_REG 0x171C
+#define RCAR_GEN2_PHY_CTL3 0x000B0194
+
+#define RCAR_GEN2_PHY_CTL4_REG 0x1724
+#define RCAR_GEN2_PHY_CTL4 0x00030994
+
+#define RCAR_GEN2_PHY_CTL5_REG 0x1740
+#define RCAR_GEN2_PHY_CTL5 0x03004001
+#define RCAR_GEN2_PHY_CTL5_DC BIT(1) /* DC connection */
+#define RCAR_GEN2_PHY_CTL5_TR BIT(2) /* Termination Resistor */
+
+enum sata_rcar_type {
+ RCAR_GEN1_SATA,
+ RCAR_GEN2_SATA,
+};
+
struct sata_rcar_priv {
void __iomem *base;
struct clk *clk;
+ enum sata_rcar_type type;
};
-static void sata_rcar_phy_initialize(struct sata_rcar_priv *priv)
+static void sata_rcar_gen1_phy_preinit(struct sata_rcar_priv *priv)
{
void __iomem *base = priv->base;
@@ -141,8 +167,8 @@ static void sata_rcar_phy_initialize(struct sata_rcar_priv *priv)
iowrite32(0, base + SATAPHYRESET_REG);
}
-static void sata_rcar_phy_write(struct sata_rcar_priv *priv, u16 reg, u32 val,
- int group)
+static void sata_rcar_gen1_phy_write(struct sata_rcar_priv *priv, u16 reg,
+ u32 val, int group)
{
void __iomem *base = priv->base;
int timeout;
@@ -170,6 +196,29 @@ static void sata_rcar_phy_write(struct sata_rcar_priv *priv, u16 reg, u32 val,
iowrite32(0, base + SATAPHYADDR_REG);
}
+static void sata_rcar_gen1_phy_init(struct sata_rcar_priv *priv)
+{
+ sata_rcar_gen1_phy_preinit(priv);
+ sata_rcar_gen1_phy_write(priv, SATAPCTLR1_REG, 0x00200188, 0);
+ sata_rcar_gen1_phy_write(priv, SATAPCTLR1_REG, 0x00200188, 1);
+ sata_rcar_gen1_phy_write(priv, SATAPCTLR3_REG, 0x0000A061, 0);
+ sata_rcar_gen1_phy_write(priv, SATAPCTLR2_REG, 0x20000000, 0);
+ sata_rcar_gen1_phy_write(priv, SATAPCTLR2_REG, 0x20000000, 1);
+ sata_rcar_gen1_phy_write(priv, SATAPCTLR4_REG, 0x28E80000, 0);
+}
+
+static void sata_rcar_gen2_phy_init(struct sata_rcar_priv *priv)
+{
+ void __iomem *base = priv->base;
+
+ iowrite32(RCAR_GEN2_PHY_CTL1, base + RCAR_GEN2_PHY_CTL1_REG);
+ iowrite32(RCAR_GEN2_PHY_CTL2, base + RCAR_GEN2_PHY_CTL2_REG);
+ iowrite32(RCAR_GEN2_PHY_CTL3, base + RCAR_GEN2_PHY_CTL3_REG);
+ iowrite32(RCAR_GEN2_PHY_CTL4, base + RCAR_GEN2_PHY_CTL4_REG);
+ iowrite32(RCAR_GEN2_PHY_CTL5 | RCAR_GEN2_PHY_CTL5_DC |
+ RCAR_GEN2_PHY_CTL5_TR, base + RCAR_GEN2_PHY_CTL5_REG);
+}
+
static void sata_rcar_freeze(struct ata_port *ap)
{
struct sata_rcar_priv *priv = ap->host->private_data;
@@ -738,13 +787,17 @@ static void sata_rcar_init_controller(struct ata_host *host)
u32 val;
/* reset and setup phy */
- sata_rcar_phy_initialize(priv);
- sata_rcar_phy_write(priv, SATAPCTLR1_REG, 0x00200188, 0);
- sata_rcar_phy_write(priv, SATAPCTLR1_REG, 0x00200188, 1);
- sata_rcar_phy_write(priv, SATAPCTLR3_REG, 0x0000A061, 0);
- sata_rcar_phy_write(priv, SATAPCTLR2_REG, 0x20000000, 0);
- sata_rcar_phy_write(priv, SATAPCTLR2_REG, 0x20000000, 1);
- sata_rcar_phy_write(priv, SATAPCTLR4_REG, 0x28E80000, 0);
+ switch (priv->type) {
+ case RCAR_GEN1_SATA:
+ sata_rcar_gen1_phy_init(priv);
+ break;
+ case RCAR_GEN2_SATA:
+ sata_rcar_gen2_phy_init(priv);
+ break;
+ default:
+ dev_warn(host->dev, "SATA phy is not initialized\n");
+ break;
+ }
/* SATA-IP reset state */
val = ioread32(base + ATAPI_CONTROL1_REG);
@@ -770,8 +823,39 @@ static void sata_rcar_init_controller(struct ata_host *host)
iowrite32(ATAPI_INT_ENABLE_SATAINT, base + ATAPI_INT_ENABLE_REG);
}
+static struct of_device_id sata_rcar_match[] = {
+ /* Deprecated, "renesas,sata-r8a7779" should be used instead. */
+ {
+ .compatible = "renesas,rcar-sata",
+ .data = (void *)RCAR_GEN1_SATA,
+ },
+ {
+ .compatible = "renesas,sata-r8a7779",
+ .data = (void *)RCAR_GEN1_SATA,
+ },
+ {
+ .compatible = "renesas,sata-r8a7790",
+ .data = (void *)RCAR_GEN2_SATA
+ },
+ {
+ .compatible = "renesas,sata-r8a7791",
+ .data = (void *)RCAR_GEN2_SATA
+ },
+ {},
+};
+MODULE_DEVICE_TABLE(of, sata_rcar_match);
+
+static const struct platform_device_id sata_rcar_id_table[] = {
+ { "sata-r8a7779", RCAR_GEN1_SATA },
+ { "sata-r8a7790", RCAR_GEN2_SATA },
+ { "sata-r8a7791", RCAR_GEN2_SATA },
+ { },
+};
+MODULE_DEVICE_TABLE(platform, sata_rcar_id_table);
+
static int sata_rcar_probe(struct platform_device *pdev)
{
+ const struct of_device_id *of_id;
struct ata_host *host;
struct sata_rcar_priv *priv;
struct resource *mem;
@@ -787,6 +871,12 @@ static int sata_rcar_probe(struct platform_device *pdev)
if (!priv)
return -ENOMEM;
+ of_id = of_match_device(sata_rcar_match, &pdev->dev);
+ if (of_id)
+ priv->type = (enum sata_rcar_type)of_id->data;
+ else
+ priv->type = platform_get_device_id(pdev)->driver_data;
+
priv->clk = devm_clk_get(&pdev->dev, NULL);
if (IS_ERR(priv->clk)) {
dev_err(&pdev->dev, "failed to get access to sata clock\n");
@@ -892,16 +982,10 @@ static const struct dev_pm_ops sata_rcar_pm_ops = {
};
#endif
-static struct of_device_id sata_rcar_match[] = {
- { .compatible = "renesas,rcar-sata", }, /* Deprecated */
- { .compatible = "renesas,sata-r8a7779", },
- {},
-};
-MODULE_DEVICE_TABLE(of, sata_rcar_match);
-
static struct platform_driver sata_rcar_driver = {
.probe = sata_rcar_probe,
.remove = sata_rcar_remove,
+ .id_table = sata_rcar_id_table,
.driver = {
.name = DRV_NAME,
.owner = THIS_MODULE,
R-Car Gen2 SoCs have a different PHY which is not compatible with the older R-Car H1 (R8A7779) version. This adds OF/platform device id tables and PHY initialization callbacks for the following Gen2 SoCs: * R-Car H2: R8A7790; * R-Car M2: R8A7791. PHY initialization method is chosen based on the device id. Default PHY settings are applied for Gen2 SoCs, which should suit the Gen2 boards available. The R8A7779 platform code is modified to use "sata-r8a7779" device name. Signed-off-by: Valentine Barshak <valentine.barshak@cogentembedded.com> --- .../devicetree/bindings/ata/sata_rcar.txt | 5 +- arch/arm/mach-shmobile/clock-r8a7779.c | 2 +- arch/arm/mach-shmobile/setup-r8a7779.c | 2 +- drivers/ata/sata_rcar.c | 118 ++++++++++++++++++--- 4 files changed, 107 insertions(+), 20 deletions(-)