@@ -10,6 +10,7 @@
/dts-v1/;
/include/ "r8a7790.dtsi"
+#include <dt-bindings/gpio/gpio.h>
/ {
model = "Lager";
@@ -28,4 +29,56 @@
#address-cells = <1>;
#size-cells = <1>;
};
+
+ leds {
+ compatible = "gpio-leds";
+ led6 {
+ gpios = <&gpio4 22 GPIO_ACTIVE_HIGH>;
+ };
+ led7 {
+ gpios = <&gpio4 23 GPIO_ACTIVE_HIGH>;
+ };
+ led8 {
+ gpios = <&gpio5 17 GPIO_ACTIVE_HIGH>;
+ };
+ };
+
+ fixedregulator3v3: fixedregulator@0 {
+ compatible = "regulator-fixed";
+ regulator-name = "fixed-3.3V";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ regulator-boot-on;
+ regulator-always-on;
+ };
+};
+
+&pfc {
+ pinctrl-0 = <&scif0_pins &scif1_pins>;
+ pinctrl-names = "default";
+
+ scif0_pins: scif0 {
+ renesas,groups = "scif0_data";
+ renesas,function = "scif0";
+ };
+
+ scif1_pins: scif1 {
+ renesas,groups = "scif1_data";
+ renesas,function = "scif1";
+ };
+
+ mmc1_pins: mmc1 {
+ renesas,groups = "mmc1_data8", "mmc1_ctrl";
+ renesas,function = "mmc1";
+ };
+};
+
+&mmcif1 {
+ pinctrl-0 = <&mmc1_pins>;
+ pinctrl-names = "default";
+
+ vmmc-supply = <&fixedregulator3v3>;
+ bus-width = <8>;
+ non-removable;
+ status = "okay";
};
Copy the device nodes from Lager reference into the Lager device tree file. This will allow us to use a single DTS file regarless of kernel configuration. In case of legacy C board code the device nodes may or may not be used, but in the multiplatform case all the DT device nodes are used. Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com> --- arch/arm/boot/dts/r8a7790-lager.dts | 53 +++++++++++++++++++++++++++++++++++++ 1 file changed, 53 insertions(+)