@@ -72,26 +72,6 @@
regulator-always-on;
};
- lbsc {
- compatible = "simple-bus";
- #address-cells = <1>;
- #size-cells = <1>;
- ranges = <0 0 0 0x20000000>;
-
- ethernet@8000000 {
- compatible = "smsc,lan9220", "smsc,lan9115";
- reg = <0x08000000 0x1000>;
- interrupt-parent = <&irqc1>;
- interrupts = <8 IRQ_TYPE_LEVEL_HIGH>;
- phy-mode = "mii";
- reg-io-width = <4>;
- smsc,irq-active-high;
- smsc,irq-push-pull;
- vdd33a-supply = <&ape6evm_fixed_3v3>;
- vddvario-supply = <&ape6evm_fixed_1v8>;
- };
- };
-
leds {
compatible = "gpio-leds";
led1 {
@@ -184,6 +164,21 @@
voltage-tolerance = <1>; /* 1% */
};
+&bsc {
+ ethernet@8000000 {
+ compatible = "smsc,lan9220", "smsc,lan9115";
+ reg = <0x08000000 0x1000>;
+ interrupt-parent = <&irqc1>;
+ interrupts = <8 IRQ_TYPE_LEVEL_HIGH>;
+ phy-mode = "mii";
+ reg-io-width = <4>;
+ smsc,irq-active-high;
+ smsc,irq-push-pull;
+ vdd33a-supply = <&ape6evm_fixed_3v3>;
+ vddvario-supply = <&ape6evm_fixed_1v8>;
+ };
+};
+
&cmt1 {
status = "okay";
};
Move the Ethernet node from the ad-hoc lbsc node to the BSC node, as its connected to the Bus State Controller. This allows the system to know the right position of the Ethernet node in the clock and PM domain hierarchy, and manage the clock and PM domain appropriately. Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be> --- Untested v2: - New --- arch/arm/boot/dts/r8a73a4-ape6evm.dts | 35 +++++++++++++++-------------------- 1 file changed, 15 insertions(+), 20 deletions(-)