@@ -81,7 +81,7 @@ struct sci_port {
/* Platform configuration */
struct plat_sci_port *cfg;
- int overrun_bit;
+ unsigned int overrun_mask;
unsigned int error_mask;
unsigned int sampling_rate;
@@ -803,7 +803,7 @@ static int sci_handle_errors(struct uart_port *port)
struct sci_port *s = to_sci_port(port);
/* Handle overruns */
- if (status & (1 << s->overrun_bit)) {
+ if (status & s->overrun_mask) {
port->icount.overrun++;
/* overrun error */
@@ -867,7 +867,7 @@ static int sci_handle_fifo_overrun(struct uart_port *port)
struct sci_port *s = to_sci_port(port);
struct plat_sci_reg *reg;
int copied = 0, offset;
- u16 status, bit;
+ u16 status;
switch (port->type) {
case PORT_SCIF:
@@ -887,10 +887,8 @@ static int sci_handle_fifo_overrun(struct uart_port *port)
return 0;
status = serial_port_in(port, offset);
- bit = 1 << s->overrun_bit;
-
- if (status & bit) {
- status &= ~bit;
+ if (status & s->overrun_mask) {
+ status &= ~s->overrun_mask;
serial_port_out(port, offset, status);
port->icount.overrun++;
@@ -1081,7 +1079,7 @@ static irqreturn_t sci_mpxed_interrupt(int irq, void *ptr)
ret = sci_br_interrupt(irq, ptr);
/* Overrun Interrupt */
- if (orer_status & (1 << s->overrun_bit))
+ if (orer_status & s->overrun_mask)
sci_handle_fifo_overrun(port);
return ret;
@@ -2256,32 +2254,32 @@ static int sci_init_single(struct platform_device *dev,
switch (p->type) {
case PORT_SCIFB:
port->fifosize = 256;
- sci_port->overrun_bit = 9;
+ sci_port->overrun_mask = SCIFA_ORER;
sampling_rate = 16;
break;
case PORT_HSCIF:
port->fifosize = 128;
sampling_rate = 0;
- sci_port->overrun_bit = 0;
+ sci_port->overrun_mask = SCLSR_ORER;
break;
case PORT_SCIFA:
port->fifosize = 64;
- sci_port->overrun_bit = 9;
+ sci_port->overrun_mask = SCIFA_ORER;
sampling_rate = 16;
break;
case PORT_SCIF:
port->fifosize = 16;
if (p->regtype == SCIx_SH7705_SCIF_REGTYPE) {
- sci_port->overrun_bit = 9;
+ sci_port->overrun_mask = SCIFA_ORER;
sampling_rate = 16;
} else {
- sci_port->overrun_bit = 0;
+ sci_port->overrun_mask = SCLSR_ORER;
sampling_rate = 32;
}
break;
default:
port->fifosize = 1;
- sci_port->overrun_bit = 5;
+ sci_port->overrun_mask = SCI_ORER;
sampling_rate = 32;
break;
}
@@ -2335,7 +2333,7 @@ static int sci_init_single(struct platform_device *dev,
* Make the error mask inclusive of overrun detection, if
* supported.
*/
- sci_port->error_mask |= 1 << sci_port->overrun_bit;
+ sci_port->error_mask |= sci_port->overrun_mask;
port->type = p->type;
port->flags = UPF_FIXED_PORT | p->flags;
@@ -87,6 +87,9 @@ enum {
#define SCFCR_RFRST BIT(1) /* Receive FIFO Data Register Reset */
#define SCFCR_LOOP BIT(0) /* Loopback Test */
+/* SCLSR (Line Status Register) on (H)SCIF */
+#define SCLSR_ORER BIT(0) /* Overrun Error */
+
/* SCSPTR (Serial Port Register), optional */
#define SCSPTR_RTSIO BIT(7) /* Serial Port RTS Pin Input/Output */
#define SCSPTR_RTSDT BIT(6) /* Serial Port RTS Pin Data */
Add the missing overrun bit definition for (H)SCIF. Replace overrun_bit by overrun_mask, so we can use the existing defines instead of hardcoded values. Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be> --- drivers/tty/serial/sh-sci.c | 28 +++++++++++++--------------- drivers/tty/serial/sh-sci.h | 3 +++ 2 files changed, 16 insertions(+), 15 deletions(-)