diff mbox

sh: smsc911x support for the rsk7203 board

Message ID 20090428080213.16323.31667.sendpatchset@rx1.opensource.se (mailing list archive)
State Accepted
Headers show

Commit Message

Magnus Damm April 28, 2009, 8:02 a.m. UTC 
From: Magnus Damm <damm@igel.co.jp>

This patch adds support for the LAN9118 ethernet on rsk7203.

The LAN9118 controller is hooked up using a 16-bit data bus,
but the rsk7203 board does not swap the byte lanes as needed
between the sh7203 processor and the the ethernet controller.

In the processor the CS memory window is configured in 16-bit
mode but the smsc911x driver is told to do 32-bit accesses to
improve performance. The SMSC911X_SWAP_FIFO flag is used
to tell the driver to do software byte swapping of fifo data.

Signed-off-by: Magnus Damm <damm@igel.co.jp>
---

 Needs "smsc911x: add fifo byteswap support V2".

 arch/sh/boards/mach-rsk/devices-rsk7203.c |    8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

--
To unsubscribe from this list: send the line "unsubscribe linux-sh" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Comments

Steve Glendinning April 28, 2009, 8:22 a.m. UTC | #1 
Magnus Damm <magnus.damm@gmail.com> wrote on 28/04/2009 09:02:13:

> From: Magnus Damm <damm@igel.co.jp>
> 
> This patch adds support for the LAN9118 ethernet on rsk7203.
> 
> The LAN9118 controller is hooked up using a 16-bit data bus,
> but the rsk7203 board does not swap the byte lanes as needed
> between the sh7203 processor and the the ethernet controller.
> 
> In the processor the CS memory window is configured in 16-bit
> mode but the smsc911x driver is told to do 32-bit accesses to
> improve performance. The SMSC911X_SWAP_FIFO flag is used
> to tell the driver to do software byte swapping of fifo data.
> 
> Signed-off-by: Magnus Damm <damm@igel.co.jp>
> ---

Acked-by: Steve Glendinning <steve.glendinning@smsc.com>

--
To unsubscribe from this list: send the line "unsubscribe linux-sh" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
diff mbox

Patch

--- 0001/arch/sh/boards/mach-rsk/devices-rsk7203.c
+++ work/arch/sh/boards/mach-rsk/devices-rsk7203.c	2009-04-21 20:30:23.000000000 +0900
@@ -26,13 +26,13 @@  static struct smsc911x_platform_config s
 	.phy_interface	= PHY_INTERFACE_MODE_MII,
 	.irq_polarity	= SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
 	.irq_type	= SMSC911X_IRQ_TYPE_OPEN_DRAIN,
-	.flags		= SMSC911X_USE_16BIT,
+	.flags		= SMSC911X_USE_32BIT | SMSC911X_SWAP_FIFO,
 };
 
 static struct resource smsc911x_resources[] = {
 	[0] = {
 		.start		= 0x24000000,
-		.end		= 0x24000000 + 0x100,
+		.end		= 0x240000ff,
 		.flags		= IORESOURCE_MEM,
 	},
 	[1] = {
@@ -99,6 +99,10 @@  static int __init rsk7203_devices_setup(
 	gpio_request(GPIO_FN_TXD0, NULL);
 	gpio_request(GPIO_FN_RXD0, NULL);
 
+	/* Setup LAN9118: CS1 in 16-bit Big Endian Mode, IRQ0 at Port B */
+	ctrl_outl(0x36db0400, 0xfffc0008); /* CS1BCR */
+	gpio_request(GPIO_FN_IRQ0_PB, NULL);
+
 	return platform_add_devices(rsk7203_devices,
 				    ARRAY_SIZE(rsk7203_devices));
 }