[v3,0/8] usb: cdns: fix suspend on J7200 by assuming reset-on-resume

Message

Théo Lebrun Feb. 23, 2024, 4:05 p.m. UTC

Hi,

Here is a new revision of the J7200 USB suspend fix. It is currently
broken on the platform, leading to a kernel panic at resume. Patches
are tested on a J7200 evaluation board, both s2idle and suspend-to-RAM.

Previous discussion showed that runtime PM was not to be deleted.
Indeed, we cannot guarantee PM domains will stay active if we don't
register to runtime PM.

We therefore rely fully on runtime PM and put our init sequence
previously done in the probe in our ->runtime_resume(). We then do the
necessary to get it called at system-wide resume for the J7200
platform.

Have a nice day,
Théo

--
Théo Lebrun, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com

Signed-off-by: Théo Lebrun <[e-mail]>
---
Changes in v3:
- dt-bindings: use an enum to list compatibles instead of the previous
  odd construct. This is done in a separate patch from the one adding
  J7200 compatible.
- dt-bindings: dropped Acked-by Conor as the changes were modified a lot.
- Add runtime PM back. Put the init sequence in ->runtime_resume(). It
  gets called at probe for all compatibles and at resume for J7200.
- Introduce a cdns_ti_match_data struct rather than rely on compatible
  from code.
- Reorder code changes. Add infrastructure based on match data THEN add
  compatible and its match data.
- DTSI: use only J7200 compatible rather than both J7200 then J721E.
- Link to v2: https://lore.kernel.org/r/[e-mail]

Changes in v2:
- Remove runtime PM from cdns3-ti; it brings nothing. That means our
  cdns3-ti suspend/resume patch is simpler; there is no need to handle
  runtime PM at suspend/resume.
- Do not add cdns3 host role suspend/resume callbacks; they are not
  needed as core detects reset on resume & calls cdns_drd_host_on when
  needed.
- cdns3-ti: Move usb2_refclk_rate_code assignment closer to the value
  computation.
- cdns3/host.c: do not pass XHCI_SUSPEND_RESUME_CLKS quirk to xHCI; it
  is unneeded on our platform.
- Link to v1: https://lore.kernel.org/r/[e-mail]

---
Théo Lebrun (8):
      dt-bindings: usb: ti,j721e-usb: drop useless compatible list
      dt-bindings: usb: ti,j721e-usb: add ti,j7200-usb compatible
      usb: cdns3-ti: move reg writes from probe into ->runtime_resume()
      usb: cdns3-ti: support reset-on-resume behavior
      usb: cdns3-ti: pass auxdata from match data to of_platform_populate()
      usb: cdns3: add quirk to platform data for reset-on-resume
      usb: cdns3-ti: add J7200 support with reset-on-resume behavior
      arm64: dts: ti: k3-j7200: use J7200-specific USB compatible

 .../devicetree/bindings/usb/ti,j721e-usb.yaml      |  10 +-
 arch/arm64/boot/dts/ti/k3-j7200-main.dtsi          |   2 +-
 drivers/usb/cdns3/cdns3-ti.c                       | 125 ++++++++++++++++-----
 drivers/usb/cdns3/core.h                           |   1 +
 drivers/usb/cdns3/host.c                           |   3 +
 5 files changed, 104 insertions(+), 37 deletions(-)
---
base-commit: 1871c27e3539e5b812d50ec6ccad7567ec5414f2
change-id: 20231113-j7200-usb-suspend-2a47f2281e04

Best regards,