new file mode 100644
@@ -0,0 +1,56 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: "http://devicetree.org/schemas/usb/microchip,usb5744.yaml#"
+$schema: "http://devicetree.org/meta-schemas/core.yaml#"
+
+title: Bindings for the Microchip USB5744 4-port Hub Controller
+
+description:
+ Microchip’s USB5744 SmartHub™ IC is a 4 port, SuperSpeed (SS)/Hi-Speed (HS),
+ low power, low pin count configurable and fully compliant with the USB 3.1
+ Gen 1 specification. The USB5744 also supports Full Speed (FS) and Low Speed
+ (LS) USB signaling, offering complete coverage of all defined USB operating
+ speeds. The new SuperSpeed hubs operate in parallel with the USB 2.0
+ controller, so 5 Gbps SuperSpeed data transfers are not affected by slower
+ USB 2.0 traffic.
+
+maintainers:
+ - Piyush Mehta <piyush.mehta@xilinx.com>
+ - Michal Simek <michal.simek@xilinx.com>
+
+properties:
+ compatible:
+ const: microchip,usb5744
+
+ reg:
+ maxItems: 1
+ description: |
+ Specifies the i2c slave address, it is required and should be 0x2d
+ if I2C is used.
+
+ reset-gpios:
+ maxItems: 1
+ description:
+ The phandle and specifier for the GPIO that controls the RESET line of
+ USB hub.
+
+required:
+ - compatible
+
+additionalProperties: false
+
+examples:
+ - |
+ #include <dt-bindings/gpio/gpio.h>
+
+ i2c {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ usb5744@2d {
+ compatible = "microchip,usb5744";
+ reg = <0x2d>;
+ reset-gpios = <&gpio 44 GPIO_ACTIVE_HIGH>;
+ };
+ };
@@ -2697,6 +2697,7 @@ W: http://wiki.xilinx.com
T: git https://github.com/Xilinx/linux-xlnx.git
F: Documentation/devicetree/bindings/i2c/cdns,i2c-r1p10.yaml
F: Documentation/devicetree/bindings/i2c/xlnx,xps-iic-2.00.a.yaml
+F: Documentation/devicetree/bindings/usb/microchip,usb5744.yaml
F: arch/arm/mach-zynq/
F: drivers/block/xsysace.c
F: drivers/clocksource/timer-cadence-ttc.c