@@ -28,6 +28,20 @@ struct ehci_ci_priv {
struct regulator *reg_vbus;
};
+/* This function is used to override WKCN, WKDN, and WKOC */
+static void ci_ehci_override_wakeup_flag(struct ehci_hcd *ehci,
+ u32 __iomem *reg, u32 flags, bool set)
+{
+ u32 val = ehci_readl(ehci, reg);
+
+ if (set)
+ val |= flags;
+ else
+ val &= ~flags;
+
+ ehci_writel(ehci, val, reg);
+}
+
static int ehci_ci_portpower(struct usb_hcd *hcd, int portnum, bool enable)
{
struct ehci_hcd *ehci = hcd_to_ehci(hcd);
@@ -170,6 +184,11 @@ static int host_start(struct ci_hdrc *ci)
otg->host = &hcd->self;
hcd->self.otg_port = 1;
}
+
+ if (ci->platdata->notify_event &&
+ (ci->platdata->flags & CI_HDRC_IMX_IS_HSIC))
+ ci->platdata->notify_event
+ (ci, CI_HDRC_IMX_HSIC_ACTIVE_EVENT);
}
return ret;
@@ -218,6 +237,8 @@ void ci_hdrc_host_destroy(struct ci_hdrc *ci)
static int ci_ehci_bus_suspend(struct usb_hcd *hcd)
{
struct ehci_hcd *ehci = hcd_to_ehci(hcd);
+ struct device *dev = hcd->self.controller;
+ struct ci_hdrc *ci = dev_get_drvdata(dev);
int port;
u32 tmp;
@@ -249,6 +270,9 @@ static int ci_ehci_bus_suspend(struct usb_hcd *hcd)
* It needs a short delay between set RS bit and PHCD.
*/
usleep_range(150, 200);
+ if (ci->platdata->flags & CI_HDRC_IMX_IS_HSIC)
+ ci_ehci_override_wakeup_flag(ehci, reg,
+ PORT_WKDISC_E | PORT_WKCONN_E, false);
break;
}
}
@@ -60,9 +60,12 @@ struct ci_hdrc_platform_data {
#define CI_HDRC_OVERRIDE_RX_BURST BIT(11)
#define CI_HDRC_OVERRIDE_PHY_CONTROL BIT(12) /* Glue layer manages phy */
#define CI_HDRC_REQUIRES_ALIGNED_DMA BIT(13)
+#define CI_HDRC_IMX_IS_HSIC BIT(14)
enum usb_dr_mode dr_mode;
#define CI_HDRC_CONTROLLER_RESET_EVENT 0
#define CI_HDRC_CONTROLLER_STOPPED_EVENT 1
+#define CI_HDRC_IMX_HSIC_ACTIVE_EVENT 2
+#define CI_HDRC_IMX_HSIC_SUSPEND_EVENT 3
int (*notify_event) (struct ci_hdrc *ci, unsigned event);
struct regulator *reg_vbus;
struct usb_otg_caps ci_otg_caps;
NXP (Freecale) imx HSIC design has some special requirements, add some flags at host code to handle them. Signed-off-by: Peter Chen <peter.chen@nxp.com> --- drivers/usb/chipidea/host.c | 24 ++++++++++++++++++++++++ include/linux/usb/chipidea.h | 3 +++ 2 files changed, 27 insertions(+)