@@ -192,6 +192,14 @@ enum {
*
*/
HCI_QUIRK_NON_PERSISTENT_SETUP,
+
+ /* When this quirk is set, hw_reset() would be run to reset the
+ * hardware, after a certain number of commands (currently 5)
+ * time out because the device fails to respond.
+ *
+ * This quirk should be set before hci_register_dev is called.
+ */
+ HCI_QUIRK_HW_RESET_ON_TIMEOUT,
};
/* HCI device flags */
@@ -313,6 +313,7 @@ struct hci_dev {
unsigned int acl_cnt;
unsigned int sco_cnt;
unsigned int le_cnt;
+ unsigned int timeout_cnt;
unsigned int acl_mtu;
unsigned int sco_mtu;
@@ -437,6 +438,7 @@ struct hci_dev {
int (*post_init)(struct hci_dev *hdev);
int (*set_diag)(struct hci_dev *hdev, bool enable);
int (*set_bdaddr)(struct hci_dev *hdev, const bdaddr_t *bdaddr);
+ void (*hw_reset)(struct hci_dev *hdev);
};
#define HCI_PHY_HANDLE(handle) (handle & 0xff)
@@ -2569,13 +2569,24 @@ static void hci_cmd_timeout(struct work_struct *work)
struct hci_dev *hdev = container_of(work, struct hci_dev,
cmd_timer.work);
+ hdev->timeout_cnt++;
if (hdev->sent_cmd) {
struct hci_command_hdr *sent = (void *) hdev->sent_cmd->data;
u16 opcode = __le16_to_cpu(sent->opcode);
- bt_dev_err(hdev, "command 0x%4.4x tx timeout", opcode);
+ bt_dev_err(hdev, "command 0x%4.4x tx timeout (cnt = %u)",
+ opcode, hdev->timeout_cnt);
} else {
- bt_dev_err(hdev, "command tx timeout");
+ bt_dev_err(hdev, "command tx timeout (cnt = %u)",
+ hdev->timeout_cnt);
+ }
+
+ if (test_bit(HCI_QUIRK_HW_RESET_ON_TIMEOUT, &hdev->quirks) &&
+ hdev->timeout_cnt >= 5) {
+ hdev->timeout_cnt = 0;
+ if (hdev->hw_reset)
+ hdev->hw_reset(hdev);
+ return;
}
atomic_set(&hdev->cmd_cnt, 1);
Add a quirk and a hook to allow the HCI core to reset the BT chip if needed (after a number of timed out commands). Use that new hook to initiate BT chip reset if the controller fails to respond to certain number of commands (currently 5) including the HCI reset commands. This is done based on a newly introduced quirk. This is done based on some initial work by Intel. Signed-off-by: Rajat Jain <rajatja@google.com> --- v2: same as v1 include/net/bluetooth/hci.h | 8 ++++++++ include/net/bluetooth/hci_core.h | 2 ++ net/bluetooth/hci_core.c | 15 +++++++++++++-- 3 files changed, 23 insertions(+), 2 deletions(-)