diff mbox series

[3/8] ARM: davinci: omapl138-hawk: use gpio lookup entries for usb gpios

Message ID 20190205102546.29457-4-brgl@bgdev.pl (mailing list archive)
State Superseded
Headers show
Series ARM: davinci: move the da8xx-ohci GPIO logic into the driver | expand

Commit Message

Bartosz Golaszewski Feb. 5, 2019, 10:25 a.m. UTC 
From: Bartosz Golaszewski <bgolaszewski@baylibre.com>

Add lookup entries for the vbus and overcurrent gpios for omapl138-hawk.

Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
---
 arch/arm/mach-davinci/board-omapl138-hawk.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

Comments

Linus Walleij Feb. 8, 2019, 1:33 p.m. UTC | #1 
On Tue, Feb 5, 2019 at 11:25 AM Bartosz Golaszewski <brgl@bgdev.pl> wrote:

> From: Bartosz Golaszewski <bgolaszewski@baylibre.com>
>
> Add lookup entries for the vbus and overcurrent gpios for omapl138-hawk.
>
> Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>

Yours,
Linus Walleij
diff mbox series

Patch

diff --git a/arch/arm/mach-davinci/board-omapl138-hawk.c b/arch/arm/mach-davinci/board-omapl138-hawk.c
index 94c4f126ef86..856c5707bae9 100644
--- a/arch/arm/mach-davinci/board-omapl138-hawk.c
+++ b/arch/arm/mach-davinci/board-omapl138-hawk.c
@@ -302,6 +302,14 @@  static const short da850_hawk_usb11_pins[] = {
 	-1
 };
 
+static struct gpiod_lookup_table hawk_usb_gpio_lookup = {
+	.dev_id		= "ohci-da8xx",
+	.table = {
+		GPIO_LOOKUP("davinci_gpio", DA850_USB1_VBUS_PIN, "vbus", 0),
+		GPIO_LOOKUP("davinci_gpio", DA850_USB1_OC_PIN, "oc", 0),
+	},
+};
+
 static int hawk_usb_set_power(unsigned port, int on)
 {
 	gpio_set_value(DA850_USB1_VBUS_PIN, on);
@@ -390,6 +398,8 @@  static __init void omapl138_hawk_usb_init(void)
 		goto usb11_setup_oc_fail;
 	}
 
+	gpiod_add_lookup_table(&hawk_usb_gpio_lookup);
+
 	ret = da8xx_register_usb11(&omapl138_hawk_usb11_pdata);
 	if (ret) {
 		pr_warn("%s: USB 1.1 registration failed: %d\n", __func__, ret);