@@ -1475,9 +1475,15 @@ int xhci_endpoint_init(struct xhci_hcd *xhci,
/* Allow 3 retries for everything but isoc, set CErr = 3 */
if (!usb_endpoint_xfer_isoc(&ep->desc))
err_count = 3;
- /* Some devices get this wrong */
- if (usb_endpoint_xfer_bulk(&ep->desc) && udev->speed == USB_SPEED_HIGH)
- max_packet = 512;
+ /* HS bulk max packet should be 512, FS bulk supports 8, 16, 32 or 64 */
+ if (usb_endpoint_xfer_bulk(&ep->desc)) {
+ if (udev->speed == USB_SPEED_HIGH)
+ max_packet = 512;
+ if (udev->speed == USB_SPEED_FULL) {
+ max_packet = rounddown_pow_of_two(max_packet);
+ max_packet = clamp_val(max_packet, 8, 64);
+ }
+ }
/* xHCI 1.0 and 1.1 indicates that ctrl ep avg TRB Length should be 8 */
if (usb_endpoint_xfer_control(&ep->desc) && xhci->hci_version >= 0x100)
avg_trb_len = 8;
A Full-speed bulk USB audio device (DJ-Tech CTRL) with a invalid Maximum Packet Size of 4 causes a xHC "Parameter Error" at enumeration. This is because valid Maximum packet sizes for Full-speed bulk endpoints are 8, 16, 32 and 64 bytes. Hosts are not required to support other values than these. See usb 2 specs section 5.8.3 for details. The device starts working after forcing the maximum packet size to 8. This is most likely the case with other devices as well, so force the maximum packet size to a valid range. Cc: stable@vger.kernel.org Reported-by: Rene D Obermueller <cmdrrdo@gmail.com> Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com> --- drivers/usb/host/xhci-mem.c | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-)