deleted file mode 100644
@@ -1,42 +0,0 @@
-Amlogic Meson GX DWC3 USB SoC controller
-
-Required properties:
-- compatible: depending on the SoC this should contain one of:
- * amlogic,meson-axg-dwc3
- * amlogic,meson-gxl-dwc3
-- clocks: a handle for the "USB general" clock
-- clock-names: must be "usb_general"
-- resets: a handle for the shared "USB OTG" reset line
-- reset-names: must be "usb_otg"
-
-Required child node:
-A child node must exist to represent the core DWC3 IP block. The name of
-the node is not important. The content of the node is defined in dwc3.txt.
-
-PHY documentation is provided in the following places:
-- Documentation/devicetree/bindings/phy/meson-gxl-usb2-phy.txt
-- Documentation/devicetree/bindings/phy/meson-gxl-usb3-phy.txt
-
-Example device nodes:
- usb0: usb@ff500000 {
- compatible = "amlogic,meson-axg-dwc3";
- #address-cells = <2>;
- #size-cells = <2>;
- ranges;
-
- clocks = <&clkc CLKID_USB>;
- clock-names = "usb_general";
- resets = <&reset RESET_USB_OTG>;
- reset-names = "usb_otg";
-
- dwc3: dwc3@ff500000 {
- compatible = "snps,dwc3";
- reg = <0x0 0xff500000 0x0 0x100000>;
- interrupts = <GIC_SPI 30 IRQ_TYPE_LEVEL_HIGH>;
- dr_mode = "host";
- maximum-speed = "high-speed";
- snps,dis_u2_susphy_quirk;
- phys = <&usb3_phy>, <&usb2_phy0>;
- phy-names = "usb2-phy", "usb3-phy";
- };
- };