diff mbox series

[1/2] xhci-pci: Only run d3cold avoidance quirk for s2idle

Message ID 20230515134059.161110-2-mathias.nyman@linux.intel.com (mailing list archive)
State Accepted
Commit 2a821fc3136d5d99dcb9de152be8a052ca27d870
Headers show
Series xhci fixes for usb-linus | expand

Commit Message

Mathias Nyman May 15, 2023, 1:40 p.m. UTC
From: Mario Limonciello <mario.limonciello@amd.com>

Donghun reports that a notebook that has an AMD Ryzen 5700U but supports
S3 has problems with USB after resuming from suspend. The issue was
bisected down to commit d1658268e439 ("usb: pci-quirks: disable D3cold on
xhci suspend for s2idle on AMD Renoir").

As this issue only happens on S3, narrow the broken D3cold quirk to only
run in s2idle.

Fixes: d1658268e439 ("usb: pci-quirks: disable D3cold on xhci suspend for s2idle on AMD Renoir")
Reported-and-tested-by: Donghun Yoon <donghun.yoon@lge.com>
Cc: stable@vger.kernel.org
Signed-off-by: Mario Limonciello <mario.limonciello@amd.com>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
---
 drivers/usb/host/xhci-pci.c | 12 ++++++++++--
 drivers/usb/host/xhci.h     |  2 +-
 2 files changed, 11 insertions(+), 3 deletions(-)
diff mbox series

Patch

diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
index ddb79f23fb3b..79b3691f373f 100644
--- a/drivers/usb/host/xhci-pci.c
+++ b/drivers/usb/host/xhci-pci.c
@@ -13,6 +13,7 @@ 
 #include <linux/module.h>
 #include <linux/acpi.h>
 #include <linux/reset.h>
+#include <linux/suspend.h>
 
 #include "xhci.h"
 #include "xhci-trace.h"
@@ -387,7 +388,7 @@  static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
 
 	if (pdev->vendor == PCI_VENDOR_ID_AMD &&
 		pdev->device == PCI_DEVICE_ID_AMD_RENOIR_XHCI)
-		xhci->quirks |= XHCI_BROKEN_D3COLD;
+		xhci->quirks |= XHCI_BROKEN_D3COLD_S2I;
 
 	if (pdev->vendor == PCI_VENDOR_ID_INTEL) {
 		xhci->quirks |= XHCI_LPM_SUPPORT;
@@ -801,9 +802,16 @@  static int xhci_pci_suspend(struct usb_hcd *hcd, bool do_wakeup)
 	 * Systems with the TI redriver that loses port status change events
 	 * need to have the registers polled during D3, so avoid D3cold.
 	 */
-	if (xhci->quirks & (XHCI_COMP_MODE_QUIRK | XHCI_BROKEN_D3COLD))
+	if (xhci->quirks & XHCI_COMP_MODE_QUIRK)
 		pci_d3cold_disable(pdev);
 
+#ifdef CONFIG_SUSPEND
+	/* d3cold is broken, but only when s2idle is used */
+	if (pm_suspend_target_state == PM_SUSPEND_TO_IDLE &&
+	    xhci->quirks & (XHCI_BROKEN_D3COLD_S2I))
+		pci_d3cold_disable(pdev);
+#endif
+
 	if (xhci->quirks & XHCI_PME_STUCK_QUIRK)
 		xhci_pme_quirk(hcd);
 
diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
index 08d721921b7b..6b690ec91ff3 100644
--- a/drivers/usb/host/xhci.h
+++ b/drivers/usb/host/xhci.h
@@ -1901,7 +1901,7 @@  struct xhci_hcd {
 #define XHCI_DISABLE_SPARSE	BIT_ULL(38)
 #define XHCI_SG_TRB_CACHE_SIZE_QUIRK	BIT_ULL(39)
 #define XHCI_NO_SOFT_RETRY	BIT_ULL(40)
-#define XHCI_BROKEN_D3COLD	BIT_ULL(41)
+#define XHCI_BROKEN_D3COLD_S2I	BIT_ULL(41)
 #define XHCI_EP_CTX_BROKEN_DCS	BIT_ULL(42)
 #define XHCI_SUSPEND_RESUME_CLKS	BIT_ULL(43)
 #define XHCI_RESET_TO_DEFAULT	BIT_ULL(44)