@@ -540,9 +540,6 @@ bimc: interconnect@400000 {
compatible = "qcom,msm8916-bimc";
reg = <0x00400000 0x62000>;
#interconnect-cells = <1>;
- clock-names = "bus", "bus_a";
- clocks = <&rpmcc RPM_SMD_BIMC_CLK>,
- <&rpmcc RPM_SMD_BIMC_A_CLK>;
};
tsens: thermal-sensor@4a9000 {
@@ -575,18 +572,12 @@ pcnoc: interconnect@500000 {
compatible = "qcom,msm8916-pcnoc";
reg = <0x00500000 0x11000>;
#interconnect-cells = <1>;
- clock-names = "bus", "bus_a";
- clocks = <&rpmcc RPM_SMD_PCNOC_CLK>,
- <&rpmcc RPM_SMD_PCNOC_A_CLK>;
};
snoc: interconnect@580000 {
compatible = "qcom,msm8916-snoc";
reg = <0x00580000 0x14000>;
#interconnect-cells = <1>;
- clock-names = "bus", "bus_a";
- clocks = <&rpmcc RPM_SMD_SNOC_CLK>,
- <&rpmcc RPM_SMD_SNOC_A_CLK>;
};
stm: stm@802000 {
Some nodes are abusingly referencing some of the internal bus clocks, that were recently removed in Linux (because the original implementation did not make much sense), managing them as if they were the only devices on an NoC bus. These clocks are now handled from within the icc framework and are no longer registered from within the CCF. Remove them. Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org> --- arch/arm64/boot/dts/qcom/msm8916.dtsi | 9 --------- 1 file changed, 9 deletions(-)