diff mbox series

[v10,11/11] arm64: dts: qcom: sa8540-ride: Enable first port of tertiary usb controller

Message ID 20230727223307.8096-12-quic_kriskura@quicinc.com (mailing list archive)
State Superseded
Headers show
Series Add multiport support for DWC3 controllers | expand

Commit Message

Krishna Kurapati July 27, 2023, 10:33 p.m. UTC 
From: Andrew Halaney <ahalaney@redhat.com>

There is now support for the multiport USB controller this uses so
enable it.

The board only has a single port hooked up (despite it being wired up to
the multiport IP on the SoC). There's also a USB 2.0 mux hooked up,
which by default on boot is selected to mux properly. Grab the gpio
controlling that and ensure it stays in the right position so USB 2.0
continues to be routed from the external port to the SoC.

Co-developed-by: Andrew Halaney <ahalaney@redhat.com>
Signed-off-by: Andrew Halaney <ahalaney@redhat.com>
[Krishna: Rebased on top of usb-next]
Co-developed-by: Krishna Kurapati <quic_kriskura@quicinc.com>
Signed-off-by: Krishna Kurapati <quic_kriskura@quicinc.com>
---
 arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
index 5a26974dcf8f..69f6b13e6197 100644
--- a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
+++ b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
@@ -488,6 +488,19 @@  &usb_2_qmpphy0 {
 	status = "okay";
 };
 
+&usb_2 {
+	pinctrl-0 = <&usb2_en_state>;
+	pinctrl-names = "default";
+
+	status = "okay";
+};
+
+&usb_2_dwc3 {
+	dr_mode = "host";
+	phy-names = "usb2-port0", "usb3-port0";
+	phys = <&usb_2_hsphy0>, <&usb_2_qmpphy0>;
+};
+
 &xo_board_clk {
 	clock-frequency = <38400000>;
 };
@@ -640,4 +653,13 @@  wake-pins {
 			bias-pull-up;
 		};
 	};
+
+	usb2_en_state: usb2-en-state {
+		/* TS3USB221A USB2.0 mux select */
+		pins = "gpio24";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+		output-low;
+	};
 };